Pacific Energy G963 Installation And Operating Instructions Manual

Download or browse on-line these Installation And Operating Instructions Manual for Pacific energy G963 Indoor Fireplace.

Pacific energy G963 Manual Information:

This manual for Pacific energy G963, given in the PDF format, is available for free online viewing and download without logging on. The guide contains 34 pages, and the size of the file at download is . The document type is Installation And Operating Instructions Manual.

Download Manual

Summary of Contents:

[Page 1] Pacific energy G963

040714 PZPE.G963BODYA 5055.963-A INSTALER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference. WARNING: If the information in these instructions is not followed exactly a fire or explosion may ...

[Page 2] Pacific energy G963

2 Important Note for the Commonwealth of Massachusetts: From Massachusetts Rules and Regulations 248 CMR 5.08: (a) For all side wall horizontally vented gas fuelled equipment installed in every dwelling, building or structure used in...

[Page 3] Pacific energy G963

3 Table of Contents Caution 4 Safety 5 Owners Information First Fire 6 Remote Control Operation 7 Maintenance 15 Lighting Instructions 16 Installer information Fir...

[Page 4] Pacific energy G963

4 FOR YOUR SAFETY - Do not install or operate your Pacific Energy gas fireplace without first reading and understanding this manual. Any installation or operational deviation from the following instructions voids the Pacif...

[Page 5] Pacific energy G963

5  Due to high temperatures, this gas appliance should be located out of traffic and away from furniture and draperies.  Children and adults should be alerted to the hazards of high surface temperatures and sh...

[Page 6] Pacific energy G963

6 OWNER’S INFORMATION Congratulations on your purchase of a Pacific Energy Gas Fireplace. Your fireplace has been professionally installed by: Dealer name: ___________________ Phone Number: _________________ If you discover any probl...

[Page 7] Pacific energy G963

7 OWNER’S INFORMATION ` Remote Control Operation Important The Proflame Transmitter is an integrated part of the Proflame System, which consists of: • Proflame Transmitter, to be used in conjunction with • Integrated F...

[Page 8] Pacific energy G963

8 OWNER’S INFORMATION Technical Data Remote Control Supply voltage 4.5 V (three AAA LR03 1.5 V batteries) Ambient temperature ratings 0 - 50 °C (32 - 1...

[Page 9] Pacific energy G963

9 OWNER’S INFORMATION Wall mounting The Proflame remote control is supplied with an adapter for wall mounting. Install the controller 1.5 m above floor level, well away from heat sources, kitche...

[Page 10] Pacific energy G963

10 OWNER’S INFORMATION Remote Flame Control The Proflame has six (6) flame levels. With the system on, and the flame level at the maximum in the appliance, pressing the down arrow key once will reduce the flame height by one s...

[Page 11] Pacific energy G963

11 OWNER’S INFORMATION ROOM THERMOSTAT (Transmitter Operation) The Remote Control can operate as a room thermostat. The thermostat can be set to a desired temperature to control the comfort level in a room. To activate this f...

[Page 12] Pacific energy G963

12 OWNER’S INFORMATION Continuous Pilot/Intermittent Pilot (CPI/IPI) selection With the system in "OFF" position press the Mode Key (Fig. 1) to index to the CPI mode icon (fig. 13 & 14). Pressing the Up Arrow Ke...

[Page 13] Pacific energy G963

13 OWNER’S INFORMATION KEY LOCK This function will lock the keys to avoid unsupervised operation. To activate this function, press the MODE and UP Keys at the same time (Fig. 17). To de-activate this function, press the MODE ...

[Page 14] Pacific energy G963

14 OWNER’S INFORMATION DIMENSIONAL DRAWINGS Fig. 19: PROFLAME Transmitter dimensional drawing ...

[Page 15] Pacific energy G963

15 OWNER’S INFORMATION Turn off gas and electrical power supply (if applicable) and allow ample time for unit to cool before servicing appliance. It is recommended that the fireplace and its venting should be inspected at least on...

[Page 16] Pacific energy G963

16 OWNER’S INFORMATION Lighting Instructions ...

[Page 17] Pacific energy G963

17 INSTALLER INFORMATION G963: Fireplace Dimensions Figure 20: Fireplace dimensions ...

[Page 18] Pacific energy G963

18 INSTALLER INFORMATION Clearances to Combustibles Minimum Clearance to Combustible Materials G963 INTERIOR SIDE WALL 4” INTERIOR BACK WALL 4 “ INTERIOR CEILING 4” IN FRONT OF APPLIANCE 36” EXTERIOR S...

[Page 19] Pacific energy G963

19 INSTALLER INFORMATION Venting Note: The vent must not exceed a total length of 28 feet. Any combination of rise and run may be used but must be constrained to the boundaries of this chart. A Maximum of three (3) 90° ...

[Page 20] Pacific energy G963

20 INSTALLER INFORMATION Figure 17: Venting This fireplace is certified for use with 4” x 6-5/8”coaxial venting components only. It is permitted to only use certified venting for this appliance. See charts on page 31 for a...

[Page 21] Pacific energy G963

21 INSTALLER INFORMATION Figure23: Gas and Electrical Connections Plumbing and Electrical Gas connection To make the required electrical and gas connections, start by positioning the gas fireplace. Connect the gas s...

[Page 22] Pacific energy G963

22 INSTALLER INFORMATION Servicing of the appliance can be performed from the rear of the unit by removing the access panel from the unit. Caution: The gas line should be installed by a qualified service person in accordance with a...

[Page 23] Pacific energy G963

23 INSTALLER INFORMATION Gas Pressure Testing Procedure Note: To test the gas pressure, turn off the gas supply to the appliance before loosening test point screws. Verify gas pressures with the fireplace lit and at the highest se...

[Page 24] Pacific energy G963

24 INSTALLER INFORMATION Before starting the conversion make sure to shut off the gas supply to the unit and allow fireplace to cool to room temperature. To convert the appliance from natural gas to propane, the (GASC.LPKIT) kit is r...

[Page 25] Pacific energy G963

25 INSTALLER INFORMATION Figure 29: Glass Retainer Figure30: Outer Door Installation 1. Position the glass retainer’s frame so that the studs on unit align with holes in frame. Secure using 12 11/32” nuts as shown...

[Page 26] Pacific energy G963

26 INSTALLER INFORMATION Note: The burner tray needs to be removed before installation or removal of panels, see page 27. Installation 1. Insert lower back panel so that it is sitting on the ledge at the back of the firebox as ...

[Page 27] Pacific energy G963

27 INSTALLER INFORMATION Burner Tray Installation / Removal Installation Place the burner tray in the firebox so that the venturi is over top of the orifice. To secure the burner tray, insert the 4 screws using a screwdriver, as ...

[Page 28] Pacific energy G963

28 INSTALLER INFORMATION Installation 1. Slide back the top cladding piece into the top of the appliance as seen in Figure 38. Fasten using screws on front of appliance shown in Figure 39. 2. Place metal grill onto lower front cla...

[Page 29] Pacific energy G963

29 INSTALLER INFORMATION Figure 42: Front Cladding Securement Figure 43: Side Cladding Stand Figure 44: Side Cladding Figure45: Side Cladding Securement Venturi Adjustment To adjust the venturi the lower fr...

[Page 30] Pacific energy G963

30 INSTALLER INFORMATION Replacement Parts Description Order Number 1. Replacement Control Module GASC.MODA 2. Replacement Gas Valve GASC.VALVEA 3. Replacement Pilot Assembly GASC.PILOT...

[Page 31] Pacific energy G963

31 INSTALLER INFORMATION NOTE: Mixing venting components from different manufacturers is inadvisable. Figure 1: 4”x6-5/8" Rigid Piping Cross Reference Chart Figure 2: 4”x6-5/8" Rigid Pipe Components Cross R...

[Page 32] Pacific energy G963

32 INSTALLER INFORMATION Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation af...

[Page 33] Pacific energy G963

33 INSTALLER INFORMATION Installation Notes ...

[Page 34] Pacific energy G963

Technical support: 1-250-748-1184 Web site: www. pacificenergy.net 2975 Allenby Rd., Duncan, BC V9l 6V8 ...