Epson Stylus pro 4000 Setup Manual

[Page 1] Epson 4000 - Stylus Pro Color Inkjet Printer

1 English Setup Guide ® Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Assembling the printer . . . . . . . . . . . . . . . . . . . . . . 4 Setting up the printer. . . . . . . . . . . . . . . . . . . . . . . . 5 Connectin...

[Page 2] Epson 4000 - Stylus Pro Color Inkjet Printer

2 All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Se...

[Page 3] Epson 4000 - Stylus Pro Color Inkjet Printer

3 English Safety Instructions Read all of these instructions before using your printer. Also be sure to follow all warnings and instructions marked on the printer. Warning, Cautions, and Notes w Warnings must be followed carefully to avoid bodily ...

[Page 4] Epson 4000 - Stylus Pro Color Inkjet Printer

4 When handling the ink cartridges ❏ Keep ink cartridges out of the reach of children and do not drink. ❏ Store ink cartridges in a cool, dark place. ❏ If ink gets on your skin, wash it off with soap and water. If it gets in your eyes, flush ...

[Page 5] Epson 4000 - Stylus Pro Color Inkjet Printer

5 English Setting up the printer Connecting the power cord 1. Check the label on the back of the printer to make sure the voltage required by the printer matches that of the power outlet you will be pulled it into. Also, make sure that you have t...

[Page 6] Epson 4000 - Stylus Pro Color Inkjet Printer

6 ❏ Each slot can hold a particular color of ink. Be sure to install the ink cartridges in the correct slot according to the ink mode you choose. 1. Turn on the printer by pressing the Power button. After a short time NO INK CRTG is displayed o...

[Page 7] Epson 4000 - Stylus Pro Color Inkjet Printer

7 English 7. After inserting all ink cartridge into each slot, lower the ink lever. The printer starts initial ink charging. 8. After approximately 2 minutes, ink lever messages appear on the LCD. When a message appears on the LCD, raise or lower...

[Page 8] Epson 4000 - Stylus Pro Color Inkjet Printer

8 Attaching the spindle to the printer To attach the paper loaded spindle to the printer, follow these steps. 1. Open the roll paper cover. 2. Raise the roll paper support. 3. Make sure that the movable flange is fixed into the end of the roll pap...

[Page 9] Epson 4000 - Stylus Pro Color Inkjet Printer

9 English 8. Hold the both fixed and movable flanges, and rewind the paper to the line marked with A4/B4. 9. Move the paper lever to the secured position. The printer automatically feeds the paper to the printing position. 10. Extend the paper tr...

[Page 10] Epson 4000 - Stylus Pro Color Inkjet Printer

10 4. Thumb through a stack of paper, then tap it on a flat surface to even the edges. If your paper is curled, flatten it before you load it. If it curls excessively and jams frequently, stop using it. 5. Clean the inside of the tray to remove an...

[Page 11] Epson 4000 - Stylus Pro Color Inkjet Printer

11 English 7. Adjust the paper guide and edge guide according to the paper size. 8. Put the paper guide roller down, and attach the paper tray cover back. Note: Make sure that roll paper support is not raised. 9. Press the Paper Source button to ...

[Page 12] Epson 4000 - Stylus Pro Color Inkjet Printer

12 Using the built-in IEEE1394 interface To connect your printer and computer using the installed IEEE 1394 interface card, follow these steps. 1. Make sure both the printer and the computer are turned off. 2. Plug the compatible interface cable ...

[Page 13] Epson 4000 - Stylus Pro Color Inkjet Printer

13 English Installing the Printer Software and EPSON Printer Service Utility 2 After connecting the printer to your computer, you need to install the software included on the Printer Software for EPSON STYLUS PRO 4000 CD-ROM shipped with your pri...

[Page 14] Epson 4000 - Stylus Pro Color Inkjet Printer

14 3. Select the appropriate Background Printing radio button to turn background printing on or off. With background printing on, you can use your Macintosh while it is preparing a document for printing. In order to use the EPSON Monitor IV util...

[Page 15] Epson 4000 - Stylus Pro Color Inkjet Printer

15 English For Windows To view or install the Reference Guide, follow these steps. 1. Insert the Printer Software for EPSON STYLUS PRO 4000 CD-ROM shipped with your printer into the CD-ROM drive. The Installer dialog box appears. 2. Choose your p...

[Page 16] Epson 4000 - Stylus Pro Color Inkjet Printer

16 ...