Litex E-AVA52BNK5CR Installation Manual

[Page 1] Litex E-AVA52BNK5CR

Installation Guide For Model: E-AVA52BNK5CR Table of Contents: Safety Tips. pg. 1 Unpacking Your Fan. pg. 2 Parts Inventory. pg. 2 Installation Preparation. pg. 3 Hanging Bracket Installation. pg. 3 Fan Assembly. pgs. 4 - 5 Wiring. pg. 5 Canopy Asse...

[Page 2] Litex E-AVA52BNK5CR

SAFETY TIPS. page 1 WARNING: To reduce the risk of electrical shock, turn off the electricity to the fan at the main fuse box or circuit panel before you begin the fan installation or before servicing the fan or installing accessories. 1. ...

[Page 3] Litex E-AVA52BNK5CR

1. Unpacking Your Fan. 2. Parts Inventory. a. canopy. 1 piece b. hanging bracket. 1 piece c. 6in. downrod and hanging ball. 1 piece d. remote control transmitter. 1 piece e. motor housing. 1 piece f. yoke cover. 1 piece g. blade. 5 pieces h. light ki...

[Page 4] Litex E-AVA52BNK5CR

3. Installation Preparation. page 3 ON OFF ON OFF To prevent personal injury and damage, ensure that the hanging location allows the blades a clearance of 7ft. (2.13m) from the floor and 30in. (76cm) from any wall or obstruction. This fan is sui...

[Page 5] Litex E-AVA52BNK5CR

page 4 5. Fan Assembly. set screw hole set screw hanging ball stop pin A B downrod electrical wiring yoke set screw yoke cover clip pin canopy motor housing If you wish to extend the hanging length of your fan, you must remove the hanging ball ...

[Page 6] Litex E-AVA52BNK5CR

5. Fan Assembly. (cont.) page 5 6. Wiring. Important: Be sure outlet box is properly grounded and that a ground wire (GREEN or Bare) is present. Use a ballpoint pen or a small screwdriver to set the code switches for the remote control transmi...

[Page 7] Litex E-AVA52BNK5CR

8. Blade Assembly. page 6 7. Canopy Assembly. blade blade attachment screws and washers blade arm blade arm screws and lock washers fan motor motor housing Locate 2 screws on underside of hanging bracket and remove screw closest to the open end o...

[Page 8] Litex E-AVA52BNK5CR

9. Light Kit Assembly. page 7 fitter plate light kit fitter wire cover glass shade BLACK WHITE WHITE BLUE Temporarily raise light kit fitter to fitter plate (on underside of motor) to determine which 2 screws in fitter plate align with slotted ...

[Page 9] Litex E-AVA52BNK5CR

page 8 10. Remote Control Operation. light dimmer setting fan setting 11. Testing Your Fan. reverse setting It is recommended that you test fan before finalizing installation. Restore power from circuit box and light switch (if applicable). Remot...

[Page 10] Litex E-AVA52BNK5CR

page 9 Troubleshooting. Problem: Fan fails to operate. Solutions: 1. Check wall switch to fan. 2. Verify that reverse switch is set completely in either direction. 3. Check to be sure code switches in remote control transmitter and receiver are set...