Sentinel MO52 Installation & Operation Manual

[Page 1] Sentinel MO52

5” B&W RearView Monitor Installation & Operation MO52 (Monitor) FOR MORE INFORMATION WWW.STRATEGICVISTA.COM BEFORE OPERATING THIS SYSTEM, PLEASE READ THIS MANUAL THOROUGHLY AND RETAIN IT FOR FUTURE REFERENCE ...

[Page 2] Sentinel MO52

Before using this unit please read these operating instructions carefully. Take special care to follow th warnings indicated on the unit itself as well as the safety suggestions listed below. Keep them handy for future reference. Power source – T...

[Page 3] Sentinel MO52

Table of Contents -2- Safety Precautions………………………………………………………. Introduction……………………………………………………………….. System Contents……………………………………�...

[Page 4] Sentinel MO52

Introduction Thank you for purchasing the Sentinel 5” Black & White RearView Monitor. This system promotes and prevents backing-up and parking accidents, by allowing you to view or check on the traffic behind your vehicle, or when rounding co...

[Page 5] Sentinel MO52

Monitor Controls Front Panel Back Panel 1. Day/Night Switch • Normally this switch should be in the out position ( DAY) • When you view the picture at night or in a tunnel, etc, depress the switch to reduce the picture brightness ( NIGHT)...

[Page 6] Sentinel MO52

8. Power Connector • Insert the supplied power cable connector firmly until it is locked • To remove the power connector, press in the clip and pull out the connector, while holding the clip down 9. Video Output Connector Connect video to a seco...

[Page 7] Sentinel MO52

Monitor Installation • Install the monitor on a surface which will support more than 4 kg (10 lbs) of weight • Install the monitor away from any speaker mounted in the vehicle so that the picture is not distorted by the speaker’s magnetic field...

[Page 8] Sentinel MO52

The connection of the power plug is shown below: GND (black) to Reverse Gear Relay or Switch (Green) to DC 10-32V Fuse & Fuse Holder (Red) Note: The Red wire with the fuse holder should be connected to car or trucks ACC Terminal, the Green ...

[Page 9] Sentinel MO52

Connections Connect the RED wire to the (10V–32V DC) power terminal, which is energized with the ignition key. Connect the BLACK wire to the metal point of the vehicle or the negative battery post. Connect the GREEN wire to the switched power out...

[Page 10] Sentinel MO52

Operating Instructions • When you turn the ignition key to the Accessory or ON position, power is supplied to the monitor and the monitor is in standby (If the Power button is not pushed in) • When you push the power button you can view the pictu...

[Page 11] Sentinel MO52

Specifications Monitor Video Format EIA Picture Tube 5 inch Black & White CRT Picture Image Factory pre-set to reverse image Picture Resolution 450 TV lines at center Power Connector ...