DeDietrich BL 150 Installation, User And Service Manual

[Page 1] DeDietrich BL 150

EN Independent domestic hot water tanks BL 150...500 M001635-B Installation, User and Service Manual 300019417-001-C ...

[Page 2] DeDietrich BL 150

Contents 1 Introduction ................................................................................................4 1.1 Used symbols .......................................................4 1.2 Abbreviations .......................................

[Page 3] DeDietrich BL 150

4.6 Hydraulic connections .......................................15 4.6.1 Hydraulic connection of the primary circuit (exchanger circuit) ....................................................................15 4.6.2 Connecting the tank to the domestic...

[Page 4] DeDietrich BL 150

3 01/03/2011 - 300019417-001-C ...

[Page 5] DeDietrich BL 150

1 Introduction 1.1 Used symbols In these instructions, various danger levels are employed to draw the user's attention to particular information. In so doing, we wish to safeguard the user's safety, obviate hazards and guarantee correct ope...

[Page 6] DeDietrich BL 150

In the interest of customers, we are continuously endeavouring to make improvements in product quality. All the specifications stated in this document are therefore subject to change without notice. Our liability as the manufacturer may not be invoke...

[Page 7] DeDietrich BL 150

1.4 Homologations 1.4.1. Certifications This product complies to the requirements to the european directives and following standards: 4 2006/95/EC Low Voltage Directive. Reference Standard: EN 60.335.1. 4 2004/108/EC Electromagnetic Compatibility Dir...

[Page 8] DeDietrich BL 150

2 Safety instructions and recommendations 2.1 Safety instructions CAUTION Before any work, switch off the mains supply to the appliance. CAUTION In order to limit the risk of being scalded, the installation of a thermostatic mixing valve on the domes...

[Page 9] DeDietrich BL 150

3 Technical description 3.1 General description BL 150...500 are high performance independent domestic hot water tanks. DHW calorifiers BL 150...500 can be connected to central heating boilers used for heating domestic hot water. Main parts: 4 The ta...

[Page 10] DeDietrich BL 150

BL 150 BL 200 BL 300 BL 400 BL 500 Power exchanged (1) kW 28 33 44 55 70 Flow per hour (∆T = 35 °C) (1) l/h 690 810 1080 1350 1720 Specific flow (∆T = 30 °C) (10 minutes) (2) l/h 220 325 510 620 780 (1) Primary temperature: 80 °C - Domesti...

[Page 11] DeDietrich BL 150

4 Installation 4.1 Regulations governing installation CAUTION Installation of the appliance must be done by a qualified engineer in accordance with prevailing local and national regulations. CAUTION France: The installation must comply in all matters...

[Page 12] DeDietrich BL 150

BL 150 BL 200 BL 300 BL 400 BL 500 Multi-voltage shielded resistor 4.5 kW - - - EC 413 EC 413 Multi-voltage steatite heating resistance 2.4 kW - EC 411 - - - Multi-voltage steatite heating resistance 3 kW - - EG 88 (2) - - SLA2 control system for l...

[Page 13] DeDietrich BL 150

4.3.3. Main dimensions M001637-C Ø G BL 150BL 200-500 H A 30 B C D E F J 1 7 7 7 11 11 2 3 4 5 6 1 BL 200 A Domestic hot water outlet (G 1) Z Exchanger inlet (G 1) E Circulation (G ¾) R Domestic cold water inlet (G 1) BL 150 - BL 200 - BL 300: D...

[Page 14] DeDietrich BL 150

4.4 Levelling The DHW tank is levelled using the feet (delivered in the instructions pack) to be screwed to the bottom of the DHW tank: 4 BL 150 - BL 200 - BL 300: 3 adjustable feet 4 BL 400 - BL 500: 4 adjustable feet (1) Adjustment range: 30 to 40...

[Page 15] DeDietrich BL 150

17 Drain cock 18 Filling the heating circuit 24 DHW tank heat exchanger primary inlet 25 DHW tank heat exchanger primary outlet 26 DHW pump 27 Non-return valve 28 Domestic cold water inlet 29 Safety unit 7-bar safety valve 30 Safety unit 32 D.H.W. lo...

[Page 16] DeDietrich BL 150

4.6 Hydraulic connections 4.6.1. Hydraulic connection of the primary circuit (exchanger circuit) ¼ See diagram : "Hydraulic installation diagram", page 13. For the hydraulic connection of 150 l to 300 l tanks and the boiler (right or left)...

[Page 17] DeDietrich BL 150

No isolating devices should be located between the valve or safety device and tank. The safety device drain pipe must have a uniform and sufficient gradient and its diameter must be at least equal to that of the outlet opening of the safety device (t...

[Page 18] DeDietrich BL 150

n Pressure reducer If the mains pressure exceeds 80% of the valve or safety unit setpoint (e.g.: 5.5 bar for a safety unit set at 7 bar), a pressure reducer must be fitted upstream of the appliance. Install the pressure reducer downstream the water m...

[Page 19] DeDietrich BL 150

4.7.2. Fitting the DHW sensor D000882 1 3 2 4 5 3 BL 150...500 4. Installation 01/03/2011 - 300019417-001-C 18 ...

[Page 20] DeDietrich BL 150

5 Commissioning 5.1 Putting the appliance into operation CAUTION Initial commissioning must be done by a qualified professional. 1. Flush the domestic circuit and fill the tank through the cold water inlet tube. 2. Open a hot water tap. 3. Completely...

[Page 21] DeDietrich BL 150

6 Checking and maintenance 6.1 General instructions CAUTION 4 Maintenance operations must be done by a qualified engineer. 4 Only original spare parts must be used. 6.2 Checking the magnesium anode Carry out a visual check of the anode. ¼ See chapte...

[Page 22] DeDietrich BL 150

Have a lip gasket and a retainer ring on hand for the inspection trap. 1. Cut off the cold water supply and drain the DHW tank. 2. Remove the inspection traps. Model BL 150 BL 200 BL 300 BL 400 BL 500 Diagram B A + C A + B A + D A + D 3. Check the an...

[Page 23] DeDietrich BL 150

6.6 Maintenance form No. _____ Date _________ Checks made ______________________________ Remarks _____________________ By _______________ Signature ____________ ...

[Page 24] DeDietrich BL 150

7 Spare parts 7.1 General When it is observed subsequent to inspection or maintenance work that a component in the appliance needs to be replaced, use only original spare parts or recommended spare parts and equipment. To order a spare part, give the...

[Page 25] DeDietrich BL 150

7.2.1. Domestic hot water tanks n BL 150 L000115-C 1 4 2 3 7 6 5 10 12 8 9 13 11 3x Markers Reference Description 1 200015416 Top black casing 2 200007092 Complete top mounting 3 89705511 Seal kit 7 mm + retainer ring 4 97860646 Adjustable foot M10...

[Page 26] DeDietrich BL 150

n BL 200 L000116-D 15 16 21 22 23 17 24 20 19 18 12 13 11 3x Markers Reference Description 11 300019411 Casing ferrule 12 95365009 Sensor attachment lug 13 200017440 Casing screw 15 300019414 Top cover 16 89555506 Complete top mounting Ø 112 17 89...

[Page 27] DeDietrich BL 150

n BL 300 L000113-D 13 11 3x 12 30 31 32 36 39 38 37 40 34 35 33 34 35 Markers Reference Description 11 300019412 Casing ferrule 12 95365009 Sensor attachment lug 13 200017440 Casing screw 30 300019414 Top black casing 31 89555501 Complete top mount...

[Page 28] DeDietrich BL 150

n BL 400 L000114-D 12 13 11 3x 45 46 47 48 49 50 55 53 52 51 54 49 50 Markers Reference Description 11 300019422 Casing ferrule 12 95365009 Sensor attachment lug 13 200017440 Casing screw 45 300019421 Top black casing 46 89555505 Cover Ø 112 with ...

[Page 29] DeDietrich BL 150

n BL 500 M001646-F 13 11 3x 12 60 63 64 65 69 68 67 66 63 64 65 61 62 Markers Reference Description 11 300019423 Casing ferrule 12 95365009 Sensor attachment lug 13 200017440 Casing screw 60 300019421 Top black casing 61 200007273 Cover Ø 112 with...

[Page 30] DeDietrich BL 150

7.2.2. Options n Titanium anode - Package EC 414 30 32 31 M000743 Markers Reference Description 30 200000093 Titanium anode 31 88014964 Wiring 32 200007959 Screw bag n 2.2 kW heating element - Package EC 410 - Ø 82 A Markers Reference Descriptio...

[Page 31] DeDietrich BL 150

Markers Reference Description 47 200008224 Clamping flange Holes, diameter 82 48 89624900 Earth wire 49 89624901 Resistance cables 50 89625507 Earthing 68 89604901 Earth wire 70 95363327 Thermostat n 2.4 kW heating element - Package EC 411 - Ø 82 4...

[Page 32] DeDietrich BL 150

n 3.3 kW heating element - Package EC 412 - Ø 82 A Markers Reference Description 41 95013133 Lip gasket Ø 82 42 200008225 Heating element 3300 W 43 89625506 Magnesium anode Ø 40 - Length 410 44 95014035 Seal ø 25 x 8.5 x 2 45 94974527 Nylon bra...

[Page 33] DeDietrich BL 150

n 4.5 kW heating element - Package EC 413 - Ø 82 A Markers Reference Description 60 95013141 Sheet gasket Ø 170 61 200008220 Heating element 4500 W 62 200007580 Complete Anode 63 95014035 Seal ø 25 x 8.5 x 2 64 94974527 Nylon brace 65 89624902 R...

[Page 34] DeDietrich BL 150

n 3 kW heating element - Package EG 88 41 -B 58 Markers Reference Description 41 95013133 Lip gasket Ø 82 53 97863562 Heating element 3000 W - Three-phase 54 97862759 Heating body 55 97866635 Fastening plate 56 200006681 Power supply wires (x3) 57...

[Page 35] DeDietrich BL 150

8 Warranty 8.1 General You have just purchased one of our appliances and we thank you for the trust you have placed in our products. Please note that your appliance will provide good service for a longer period of time if it is regularly checked and ...

[Page 36] DeDietrich BL 150

4 the rules of the profession. The warranty is limited to the exchange or repair of such parts as have been recognised to be faulty by our technical department and does not cover labour, travel and carriage costs. The warranty shall not apply to the ...

[Page 37] DeDietrich BL 150

BL 150...500 8. Warranty 01/03/2011 - 300019417-001-C 36 ...

[Page 38] DeDietrich BL 150

...

[Page 39] DeDietrich BL 150

...

[Page 40] DeDietrich BL 150

DE DIETRICH THERMIQUE S.A.S. www.dedietrich-thermique.fr DE DIETRICH REMEHA GmbH www.dedietrich-remeha.de VAN MARCKE www.vanmarcke.be WALTER MEIER (Klima Schweiz) AG www.waltermeier.com DE BE CH NEUBERG S.A. www.dedietrich-heating.com LU FR DE DIE...