HeliArtist UH-60 Instruction Manual

[Page 1] HeliArtist UH-60

...

[Page 2] HeliArtist UH-60

Thank you for buying HeliArtist Products. 500 scale fuselage is designed as an easy way to assembly. Please read this instruction manual carefully before assembling the model,and follow all precautions and recommendations in the manual.Make sure to...

[Page 3] HeliArtist UH-60

500 scale fuselge suitable for T-REX500 Helicopter series BEFORE ASSEMBLING 1:Check for all the parts in the list shown bellow. 2:Some basic tools are needed for the assembly. TOOL 1:Cutter knife. 2:Hexagon screw driver 3:Phillips ...

[Page 4] HeliArtist UH-60

Front view of the Front Landing Gears installed. Secure the Front Landing Gear using M3x16 Hex Cap Screw x2 and M3x12 Hex Cap Screw x2. Install two Front Landing Gears onto the body of the fuselage. Drill four holes under the tail part of the...

[Page 5] HeliArtist UH-60

Insert the Trex 500 Heli mechanism into the fuselage. Disassemble the upper tail part from the Scorpion Tail System after the testing as to get ready to install the heli mechanism into the fuselage body. Reassemble the Upper Tail Par...

[Page 6] HeliArtist UH-60

Install the Linkages onto the Linkage Ball of Tail Rotor Arm. Secure the Tail Cover back onto the fuselage. Adjust the position of the Heli Mechanism on the fuselage and secure the heli mechanism to the fuselage using ￠ 2X8 Self-Tap Scr...

[Page 7] HeliArtist UH-60

Glue the Rocket Launcher Arms onto the Fuselage Body using epoxy. Drill 2 holes on the Rocket Launcher and secure the Large Rocket using ￠ 2X12 Self-Tap Screws x4. Glue the Rocket Launchers onto the Rocket Launcher Arm using epoxy. 19 20 21 Glu...

[Page 8] HeliArtist UH-60

Secure the Front Window using four ￠ 1.7X6 Self- Tap Screws, and gule the Side Windows and Under Side Windows to the canopy of the fuselage. Glue the Upper window onto the canopy with epoxy or CA glue. Glue the Mid-Side Films onto the fuselage w...

[Page 9] HeliArtist UH-60

End of Manual Glue the LED cover as to finish the assembly. Install the Plastic Parts to the fuselage with epoxy or CA glue. 31 32 33 34 Glue the Decorative Wing on the front canopy using epoxy. Install the Plastic Parts to the fuselage with epo...