Compaq 8000f - Elite Ultra-slim Desktop PC Hardware Reference Manual

Download or browse on-line these Hardware Reference Manual for HP Compaq Elite 8000f USDT Desktop.

HP Compaq Elite 8000f USDT Manual Information:

This manual for HP Compaq Elite 8000f USDT, given in the PDF format, is available for free online viewing and download without logging on. The guide contains 48 pages, and the size of the file at download is 2.99 Mb. The document type is Hardware Reference Manual.

Download Manual

More Manuals:

In case you failed to obtain relevant information in this document, please, look through related operating manuals and user instructions for HP Compaq Elite 8000f USDT. Just click one of the links below to go to the selected manual:

Summary of Contents:

[Page 1] HP Compaq Elite 8000f USDT

Hardware Reference Guide HP Compaq 8000f Elite Ultra-Slim Desktop Business PC ...

[Page 2] HP Compaq Elite 8000f USDT

© Copyright 2009 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. Microsoft, Windows, and Windows Vista are either trademarks or registered trademarks of Microsoft Corporation in the Uni...

[Page 3] HP Compaq Elite 8000f USDT

About This Book This guide provides basic information for upgrading this computer model. WARNING! Text set off in this manner indicates that failure to follow directions could result in bodily harm or loss of life. CAUTION: Text set off in this manne...

[Page 4] HP Compaq Elite 8000f USDT

iv About This Book ENWW ...

[Page 5] HP Compaq Elite 8000f USDT

Table of contents 1 Product Features Standard Configuration Features ......................................................................................................... 1 Front Panel Components ....................................................

[Page 6] HP Compaq Elite 8000f USDT

Appendix C Security Lock Provisions Installing a Security Lock .................................................................................................................... 32 HP/Kensington MicroSaver Security Cable Lock ........................

[Page 7] HP Compaq Elite 8000f USDT

1 Product Features Standard Configuration Features The HP Compaq Ultra-Slim Desktop computer comes with features that may vary depending on the model. For a complete listing of the hardware and software installed in the computer, run the diagnostic u...

[Page 8] HP Compaq Elite 8000f USDT

Front Panel Components Drive configuration may vary by model. Figure 1-2 Front Panel Components Table 1-1 Front Panel Components 1 Optical Drive 5 Microphone/Headphone Connector 2 System Power LED 6 USB (Universal Serial Bus) Ports 3 SD Media Card ...

[Page 9] HP Compaq Elite 8000f USDT

Rear Panel Components Figure 1-3 Rear Panel Components Table 1-2 Rear Panel Components 1 Line-Out Connector for powered audio devices (green) 6 Power Cord Connector 2 PS/2 Keyboard Connector (purple) 7 Line-In Audio Connector (blue) 3 Universal S...

[Page 10] HP Compaq Elite 8000f USDT

Keyboard Figure 1-4 Keyboard Components Table 1-3 Keyboard Components 1 Function Keys Perform special functions depending on the software application being used. 2 Editing Keys Include the following: Insert, Home, Page Up, Delete, End, and Page Dow...

[Page 11] HP Compaq Elite 8000f USDT

Windows Logo Key + d Displays the Desktop Windows Logo Key + m Minimizes all open applications Shift + Windows Logo Key + m Undoes Minimize All Windows Logo Key + e Launches My Computer Windows Logo Key + f Launches Find Document Windows Logo Key + C...

[Page 12] HP Compaq Elite 8000f USDT

Serial Number Location Each computer has a unique serial number and a product ID that are located on the top of the computer when it is in the tower configuration. Keep these numbers available for use when contacting customer service for assistance. ...

[Page 13] HP Compaq Elite 8000f USDT

2 Hardware Upgrades Serviceability Features The computer includes features that make it easy to upgrade and service. No tools are needed for most of the installation procedures described in this chapter. Warnings and Cautions Before performing upgrad...

[Page 14] HP Compaq Elite 8000f USDT

Connecting the Power Cord When connecting the power supply, it is important to follow the steps below to ensure the power cord does not pull free from the computer. 1. Connect the round end of the power cord to the power supply connector on the rear ...

[Page 15] HP Compaq Elite 8000f USDT

Removing the Computer Access Panel To access internal components, you must remove the access panel: 1. Remove/disengage any security devices that prohibit opening the computer. 2. Remove all removable media, such as compact discs or USB flash drives,...

[Page 16] HP Compaq Elite 8000f USDT

Replacing the Computer Access Panel 1. Align the tabs on the panel with the slots on the chassis then slide the panel towards the front of the chassis until it stops (1). 2. Tighten the thumbscrew to secure the access panel (2). Figure 2-3 Replacing...

[Page 17] HP Compaq Elite 8000f USDT

Removing and Replacing the Front Bezel 1. Remove/disengage any security devices that prohibit opening the computer. 2. Remove all removable media, such as compact discs or USB flash drives, from the computer. 3. Turn off the computer properly through...

[Page 18] HP Compaq Elite 8000f USDT

To replace the front bezel: 1. Insert the three hooks on the bottom side of the bezel into the rectangular holes on the chassis (1) then rotate the top side of the bezel onto the chassis (2) and snap it into place. Figure 2-5 Replacing the Front Bez...

[Page 19] HP Compaq Elite 8000f USDT

Removing a Bezel Blank On some models, there is a bezel blank covering the external drive bay that needs to be removed before installing a drive. To remove a bezel blank: 1. Remove the front bezel. 2. Push the two retaining tabs that hold the bezel b...

[Page 20] HP Compaq Elite 8000f USDT

Changing from Desktop to Tower Configuration 1. Remove/disengage any security devices that prohibit opening the computer. 2. Remove all removable media, such as compact discs or USB flash drives, from the computer. 3. Turn off the computer properly t...

[Page 21] HP Compaq Elite 8000f USDT

Installing Additional Memory The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3- SDRAM) small outline dual inline memory modules (SODIMMs). SODIMMs The memory sockets on the system board can be populated with up...

[Page 22] HP Compaq Elite 8000f USDT

Populating SODIMM Sockets There are two SODIMM sockets on the system board, with one socket per channel. The sockets are labeled XMM1 and XMM3. The XMM1 socket operates in memory channel A. The XMM3 socket operates in memory channel B. Figure 2-8 SO...

[Page 23] HP Compaq Elite 8000f USDT

Installing SODIMMs CAUTION: You must disconnect the power cord and wait approximately 30 seconds for the power to drain before adding or removing memory modules. Regardless of the power-on state, voltage is always supplied to the memory modules as lo...

[Page 24] HP Compaq Elite 8000f USDT

8. If you are adding a second SODIMM, remove the SODIMM from the top XMM1 socket to access the bottom XMM3 socket. Press outward on the two latches on each side of the SODIMM (1) then pull the SODIMM out of the socket (2). Figure 2-9 Removing a SODI...

[Page 25] HP Compaq Elite 8000f USDT

13. Reconnect the power cord and turn on the computer. 14. Lock any security devices that were disengaged when the computer cover or access panel was removed. The computer automatically recognizes the additional memory when you turn on the computer. ...

[Page 26] HP Compaq Elite 8000f USDT

Preparing the New Optical Drive Before the new optical drive can be used, the release latch must be attached. 1. Peel the backing off the adhesive on the release latch. 2. Without allowing the release latch to touch the optical drive, carefully align...

[Page 27] HP Compaq Elite 8000f USDT

3. Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1), then connect the cable to the rear of the drive (2). Figure 2-13 Installing the Optical Drive 4. Replace the access panel. 5. If the computer ...

[Page 28] HP Compaq Elite 8000f USDT

Replacing the Hard Drive NOTE: The Ultra-Slim Desktop supports only 2.5-inch Serial ATA (SATA) internal hard drives; parallel ATA (PATA) internal hard drives are not supported. Before you remove the old hard drive, be sure to back up the data from th...

[Page 29] HP Compaq Elite 8000f USDT

9. Lift the hard drive carrier straight up and out of the chassis. Figure 2-15 Removing the Hard Drive Carrier 10. Remove the four guide screws from the sides of the hard drive carrier. Figure 2-16 Removing the Guide Screws 11. Lift the hard drive ...

[Page 30] HP Compaq Elite 8000f USDT

12. Position the hard drive so that the top of the hard drive is up against the top of the carrier (1) so that the circuit board on the bottom of the hard drive does not come in contact wit the tabs on the bottom of the carrier, then slide the new ha...

[Page 31] HP Compaq Elite 8000f USDT

14. To place the hard drive carrier back in the chassis, align the guide screws with the slots on the drive bay, drop the carrier straight down into the drive bay (1), and press the handle on the carrier all the way down (2) so that the drive is prop...

[Page 32] HP Compaq Elite 8000f USDT

Installing and Removing a Port Cover An optional rear port cover is available for the computer. To install the port cover: 1. Thread the cables through the bottom hole on the port cover (1) and connect the cables to the rear ports on the computer. 2....

[Page 33] HP Compaq Elite 8000f USDT

A Specifications Table A-1 Specifications Desktop Dimensions (in the desktop position) Height Width Depth (depth will increase if the computer is equipped with a port security bracket) 2.60 in 9.90 in 10.00 in 6.6 cm 25.1 cm 25.4 cm Approximate Weig...

[Page 34] HP Compaq Elite 8000f USDT

Rated Input Current (maximum) 1 2.4A @ 100VAC 1.2A @ 200VAC 1 This system utilizes an active power factor corrected external power supply. This allows the system to pass the CE mark requirements for use in the countries of the European Union. The act...

[Page 35] HP Compaq Elite 8000f USDT

B Battery Replacement The battery that comes with the computer provides power to the real-time clock. When replacing the battery, use a battery equivalent to the battery originally installed in the computer. The computer comes with a 3-volt lithium c...

[Page 36] HP Compaq Elite 8000f USDT

NOTE: On some computer models, it may be necessary to remove an internal component to gain access to the battery. 8. Depending on the type of battery holder on the system board, complete the following instructions to replace the battery. Type 1 a. Li...

[Page 37] HP Compaq Elite 8000f USDT

b. Insert the new battery and position the clip back into place. Figure B-3 Removing a Coin Cell Battery (Type 3) NOTE: After the battery has been replaced, use the following steps to complete this procedure. 9. Replace the access panel. 10. If the ...

[Page 38] HP Compaq Elite 8000f USDT

C Security Lock Provisions NOTE: For information on data security features, refer to the Desktop Management Guide and the HP ProtectTools Security Manager Guide (some models) at http://www.hp.com. The security locks displayed below and on the follow...

[Page 39] HP Compaq Elite 8000f USDT

Figure C-2 Installing a Cable with a Port Cover Installed Padlock Figure C-3 Installing a Padlock ENWW Installing a Security Lock 33 ...

[Page 40] HP Compaq Elite 8000f USDT

HP Business PC Security Lock 1. Fasten the security cable by looping it around a stationary object. Figure C-4 Securing the Cable to a Fixed Object 2. Thread the keyboard and mouse cables through the lock. Figure C-5 Threading the Keyboard and Mous...

[Page 41] HP Compaq Elite 8000f USDT

3. Screw the lock to the chassis using the screw provided. Figure C-6 Attaching the Lock to the Chassis 4. Insert the plug end of the security cable into the lock (1) and push the button in (2) to engage the lock. Use the key provided to disengage t...

[Page 42] HP Compaq Elite 8000f USDT

4. Disconnect the power cord from the power outlet and disconnect any external devices. CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disco...

[Page 43] HP Compaq Elite 8000f USDT

9. Install the security screw through the middle front bezel release tab and into the chassis to secure the front bezel in place. Figure C-9 Installing the Front Bezel Security Screw 10. Replace the access panel. 11. If the computer was on a stand, ...

[Page 44] HP Compaq Elite 8000f USDT

D Electrostatic Discharge A discharge of static electricity from a finger or other conductor may damage system boards or other static-sensitive devices. This type of damage may reduce the life expectancy of the device. Preventing Electrostatic Damage...

[Page 45] HP Compaq Elite 8000f USDT

E Computer Operating Guidelines, Routine Care and Shipping Preparation Computer Operating Guidelines and Routine Care Follow these guidelines to properly set up and care for the computer and monitor: ● Keep the computer away from excessive moisture...

[Page 46] HP Compaq Elite 8000f USDT

Optical Drive Precautions Be sure to observe the following guidelines while operating or cleaning the optical drive. Operation ● Do not move the drive during operation. This may cause it to malfunction during reading. ● Avoid exposing the drive t...

[Page 47] HP Compaq Elite 8000f USDT

Index A access panel locking and unlocking 32 removing 9 replacing 10 application key 4 audio connectors 2 B battery replacement 29 bezel, removing 11 C cable lock 32 components front panel 2 keyboard 4 rear panel 3 computer changing from desktop to ...

[Page 48] HP Compaq Elite 8000f USDT

power supply operating voltage range 27 product ID location 6 R rear panel components 3 release latch attaching optical drive 20 removing access panel 9 battery 29 bezel blanks 13 front bezel 11 hard drive 22 optical drive 19 port cover 26 RJ-45 conn...