Weider WESY81080 User's Manual

Download or browse on-line these Operation & User’s Manual for Weider WESY81080 Home Gym.

Weider WESY81080 Manual Information:

This manual for Weider WESY81080, given in the PDF format, is available for free online viewing and download without logging on. The guide contains 25 pages, and the size of the file at download is 0.69 Mb. The document type is Operation & User’s Manual.

Download Manual

Summary of Contents:

[Page 1] Weider WESY81080

¨ USERÕS MANUAL Model No. WESY81080 Serial No. The serial number is found in the location shown below. Write the serial number in the space above. CAUTION Read all precautions and instruc- tions in this manual before using this equipment. Save thi...

[Page 2] Weider WESY81080

2 Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

[Page 3] Weider WESY81080

3 WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for persons over the age of 35 or persons with pre-existing health problems. Read all instructions before using. ICON assumes no responsibi...

[Page 4] Weider WESY81080

4 ASSEMBLED DIMENSIONS: Height: 77 in. Width: 38 in. Length: 61 in. Low Pulley Station Foot Plate Row Bar High Pulley Station Leg Lever Butterfly Arm Butterfly Arm Press Arm Shroud Covering Weight Stack Seat Backrest Thank you for selecting the v...

[Page 5] Weider WESY81080

5 Note: This introduction will save you more time than it takes to read it! Identifying Parts To help you identify the small parts used in assem- bly, we have included a PART IDENTIFICATION CHART located in the center of this manual. Place the chart ...

[Page 6] Weider WESY81080

6 1. Before beginning assembly, make sure you have read and understood the information on page 5. Locate and open the parts bag labeled ÒFRAME ASSEMBLY.Ó Press a 2Ó Square Outer Cap (51) onto each end of the Stabilizer (5). Insert two 5/16Ó x 2 3...

[Page 7] Weider WESY81080

7 4. Set two Weight Bumpers (19) onto the Base (8) and align them with the indicated holes. Insert both Weight Guides (23) through the Weight Bumpers (19) and the holes in the Base (8). Slide eight Weights (26) onto the Weight Guides (23). Make sur...

[Page 8] Weider WESY81080

8 7. Slide two 5/16Ó Flat Washers (56) onto two 5/16Ó x 1 3/4Ó Bolts (58). Align the holes in the bracket on the Top Frame (1) with the holes in the Rear Upright (18). Insert the 5/16Ó x 1 3/4Ó Bolts (58) and hand tighten two 5/16Ó Nylon Lockn...

[Page 9] Weider WESY81080

9 11. Press a 2Ó Square Inner Cap (21) into the top end of each Press Arm (46). Press a 1Ó Round Inner Cap (49) into the indicated hole on each Press Arm (46). Attach each Press Arm (46) to the Press Frame (12) with two 5/16Ó x 2 3/4Ó Bolts (67)...

[Page 10] Weider WESY81080

10 14. Locate and open the parts bag labeled ÒCABLE ASSEMBLY AND PULLEYS.Ó For Cable identifica- tion and routing during steps 14Ð28, refer to the Cable Diagram and Cable ID Chart on page 16. Locate the Short Cable (9). It is approximately 127Ò l...

[Page 11] Weider WESY81080

11 17. Move to the other side of the unit. Wrap the Short Cable (9) around a 3 1/2Ó Pulley (35) in the direction shown. Attach the 3 1/2Ó Pulley (35) and a Cable Trap (66) to the Right Butterfly Arm (48) with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nyl...

[Page 12] Weider WESY81080

12 20. Wrap the Short Cable (9) around a 3 1/2Ó Pulley (35) in the direction shown. Attach the 3 1/2Ó Pulley (35) to the front bracket (M) underneath the Top Frame (1) with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon Locknut (63). Make sure the Bolt ...

[Page 13] Weider WESY81080

13 25. Thread the Long Cable (2) through the Press Frame (12). Wrap the Long Cable around a 3 1/2Ó Pulley (35) in the direction shown. Attach the Pulley to the Press Frame with a 3/8Ó x 3 1/4Ó Bolt (69), a Cable Trap (66), a 3/8Ó Flat Washer (55...

[Page 14] Weider WESY81080

14 28. Wrap the Long Cable (2) around a 3 1/2Ó Pulley (35) in the direction shown. Attach the Pulley to the Front Upright (42) with a 3/8Ó x 3 1/2Ó Bolt (54), a Cable Trap (66), a 3/8Ó Flat Washer (55) and a 3/8Ó Nylon Jamnut (57). Attach the cl...

[Page 15] Weider WESY81080

15 31. Press two 3/4Ó Round Inner Caps (34) into each Pad Tube (28). Insert one Pad Tube into the Seat Frame (36). Slide a Foam Pad (30) onto each end of the Pad Tube. Insert the other Pad Tube into the Leg Lever (29). Slide a Foam Pad (30) onto e...

[Page 16] Weider WESY81080

16 Cable Diagram The Cable Diagram below shows the proper routing of the Short Cable (9) and the Long Cable (2). The numbers show the correct route for each Cable. Make sure the Cables are routed correctly, that the Pulleys move smoothly and that the...

[Page 17] Weider WESY81080

Attaching the Lat Bar, Row Bar or Handle to the High Pulley Station Attach the Lat Bar (76) to the Short Cable (9) with a Cable Clip (73). For some exercises, the Chain (74) should be attached between the Lat Bar and the Long Cable with two Cable Cli...

[Page 18] Weider WESY81080

18 Press Butterfly High Leg Low Weight Arm Arm Pulley Lever Pulley Plates (lbs.) (lbs.) (lbs.) (lbs.) (lbs.) Top 12 46 19 21 15 1 40 70 33 37 33 2 62 97 49 54 45 3 86 110 68 68 59 4 94 141 81 88 72 5 127 162 96 100 87 6 150 180 110 109 102 7 160 19...

[Page 19] Weider WESY81080

19 Tightening the Cables Woven cable, the type of cable used on the home gym system, can stretch slightly when it is first used. If there is slack in the Cables before resistance is felt, the Cables should be tightened. To tighten the Cables, insert...

[Page 20] Weider WESY81080

5/16" x 1 1/2" Bolt (61) 1/4" x 2" Bolt (71) 1/4" x 2" Carriage Bolt (38) 1/4" x 2 1/2" Screw (43) 5/16" x 2 3/4" Bolt (67) 5/16" x 2 1/2" Carriage Bolt (52) 5/16" x 2 3/4" Carriag...

[Page 21] Weider WESY81080

1" Retainer (4) 1/4" Flat Washer (81) 3/8" x 2" Bolt (62) 3/8" x 3 1/2" Bolt (54) 3/8" x 8" Bolt (59) Cable Clip (73) 3/8" x 3 1/4" Bolt (69) 1/4" x 1/2" Screw (17) 3/8" x 1 1/2" B...

[Page 22] Weider WESY81080

1" Round Inner Cap (49) 1" Round Cover Cap (3) 3/4" Round Inner Cap (34) 5/16" x 2" Eyebolt (44) 1 1/2" Square Inner Cap (33) 2" Square Inner Cap (21) 2" Square Outer Cap (51) 1" x 2Ó Inner Cap (11) ...

[Page 23] Weider WESY81080

60 31 31 35 35 57 34 34 30 30 44 33 28 30 34 28 30 34 81 22 82 71 38 17 37 13 53 33 29 36 9 58 53 23 16 25 64 26 74 73 75 19 45 45 21 21 3 4 4 3 15 62 66 35 63 15 48 47 2 7 7 7 7 7 11 58 56 53 53 18 61 53 53 39 5 51 51 14 52 8 53 1 63 62 35 35 63 62 ...

[Page 24] Weider WESY81080

Note: Ò#Ó indicates a non-illustrated part. Specifications are subject to change without notice. 1 1 Top Frame 2 1 Long Cable 3 2 1Ó Round Cover Cap 4 4 1Ó Retainer 5 1 Stabilizer 6 2 ÒVÓ-Pulley 7 20 #8 x 1/2Ó Tap Screw 8 1 Base 9 1 Short Cab...

[Page 25] Weider WESY81080

Ordering Replacement Parts To order replacement parts, simply call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). To help us assist you, please be pre- pared...