Enterasys Networks DFE-256MB-UGK Installation Instructions

[Page 1] Enterasys DFE-256MB-UGK

PN 9033946 Page 1 of 5 DFE Series Module Memory Upgrade Kit (DFE-256MB-UGK) Installation Instructions Before You Begin These installation instructions describe how to upgrade the Dual-Inline Memory Module (DIMM) on a DFE series module from 128 MB to...

[Page 2] Enterasys DFE-256MB-UGK

Preparation Page 2 of 5 PN 9033946 Preparation The DIMM is located on the main pc board assembly of the DFE Series Module. In some cases, depending on the module to be upgraded, it may be necessary to remove a daughter board to gain access to the e...

[Page 3] Enterasys DFE-256MB-UGK

DIMM Replacement Procedure PN 9033946 Page 3 of 5 DIMM Replacement Procedure Although the following replacement procedure describes how to replace a DIMM in an angled connector, the procedure also applies to DIMM replacement in a vertical connector....

[Page 4] Enterasys DFE-256MB-UGK

Completing the Installation Page 4 of 5 PN 9033946 3. Push the DIMM ➁ further into the connector until the two DIMM alignment notches ➄ and the tabs on the two connector arms ➀ lock the DIMM into place. Figure 2 Installing the DIMM Completi...

[Page 5] Enterasys DFE-256MB-UGK

Getting Help PN 9033946 Page 5 of 5 Getting Help For additional support related to the module or this document, contact Enterasys Networks using one of the following methods: / Before contacting Enterasys Networks for technical support, have the fol...