Thermador HS-HST-HSB Installation Manual

Download or browse on-line these Installation Instructions Manual for Thermador HS-HST-HSB Ventilation Hood.

Thermador HS-HST-HSB Manual Information:

This manual for Thermador HS-HST-HSB, given in the PDF format, is available for free online viewing and download without logging on. The guide contains 17 pages, and the size of the file at download is 0.98 Mb. The document type is Installation Instructions Manual.

Download Manual

Summary of Contents:

[Page 1] Thermador HS-HST-HSB

READ AND SAVE THESE INSTRUCTIONS INSTALLATION INSTRUCTIONS HS-HST-HSB WALL HOODS APPROVED FOR RESIDENTIAL APPLIANCES FOR RESIDENTIAL USE ONLY PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. INSTALLATION MUST COMPLY WITH ALL LOCAL CODES. IMPORTAN...

[Page 2] Thermador HS-HST-HSB

Page 2 IMPORTANT SAFETY INSTRUCTIONS CAUTION: FOR GENERAL VENTI- LATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VA- PORS. WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:...

[Page 3] Thermador HS-HST-HSB

Page 3 IMPORTANT SAFETY INSTRUCTIONS WARNING - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE. a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly ...

[Page 4] Thermador HS-HST-HSB

Page 4 ATTENTION: SEULEMENT POUR L’UTILISATION D’AÉRATION. NE PAS L’UTILISER POUR ÉPUISER LA VAPEUR OU LES MATIÈRES EXPLOSIVES OU DANGEREUSES. AVERTISSEMENT - POUR RÉDUIRE LE RISQUE D’INCENDIE, DE CHOC ÉLECTRIQUE, OU DE LA BLESSURE AUX...

[Page 5] Thermador HS-HST-HSB

Page 5 LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES AVERTISSEMENT - POUR RÉDUIRE LE RISQUE D’UN FEU DE GRAISSE DU SOMMET DE LA CUISINIÈRE: 1. Garder le ventilateur, les filtres et les surfaces chargées de la graisse propres. 2. Toujours mettre...

[Page 6] Thermador HS-HST-HSB

Page 6 Parts Included with your Hood • Hood Canopy Assembly with Light Bulbs Installed  Care & Use /Installation Instructions  Registration Card  Filters, 2, 3 or 4 depending on model and size  Metal Transition with Back draft dampe...

[Page 7] Thermador HS-HST-HSB

Page 7 BEFORE INSTALLING HOOD 1. For the most efficient air flow exhaust, use a straight run or as few elbows as possible. CAUTION: Vent unit to outside of building, only. 2. Almost two people are necessary for installation. 3. The hood is fitted ...

[Page 8] Thermador HS-HST-HSB

Page 8 HOOD WIDTH DIM. "A" 30" 12 - 3/16" 36" 15 - 3/16" 42" 18 - 3/16" 48" 21 - 3/16" HOOD DEPTH DIM. "B" 30" 22 - 11/16" 36" 23" 42" 23 - 5/16" 48" 23 - ...

[Page 9] Thermador HS-HST-HSB

Page 9 TYPICAL INSTALLATION The hoods are designed for either vertical or horizontal discharge as shown in Figure A and B respectively. The height from the countertop to the bottom of the hood is 30" to 36”.These hoods are not recommended...

[Page 10] Thermador HS-HST-HSB

Page 10 plate fixing point Plate Figure 3 Discharge Direction: The hood is shipped ready for horizontal discharge. To change to vertical discharge move plate to the rear side and ventilator (if supplied) to the top side. The plate an...

[Page 11] Thermador HS-HST-HSB

Page 11 closed. Wall Mount Installation - HS and HSB series only. (see Figure 5) 1. After the hood installation height has been determined draw a horizontal line at a distance above the cooktop equal to the desired hood installation height pl...

[Page 12] Thermador HS-HST-HSB

Page 12 Wall Mount Installation - HST series Hood only (see Figure 6-7-8) 1. Hood Installation Height After the hood installation height has been determined draw a horizontal line at a distance above the cooktop equal to the desired hood inst...

[Page 13] Thermador HS-HST-HSB

Page 13 three or four studs as available. Countersink the heads to pre- vent interference with the hood. 8. On the wood bracket mark the locations used to hang the hood according to Figure 7. 9. Drill a 1/8 tap hole through the wooden brac...

[Page 14] Thermador HS-HST-HSB

Page 14 Cabinet Installation: (Figure 5) Note: distances on page 10, Table 3. 1. Find the centerline of the cabinet bottom. Draw a line along this centerline from rear to front of the cabinet. 2. Draw two lines, one at a K distance fr...

[Page 15] Thermador HS-HST-HSB

Page 15 From Control Panel Motor connector VTN 420 or VTN 620 Wiring the HOOD with an IntegralVentilator: Warning: Turn off electricity at the service panel before wiring the unit. 1. Connect the Integral Ventilator molex plug connector to ...

[Page 16] Thermador HS-HST-HSB

Page 16 REMOTE VENTILATOR INSTALLATION Models VTR600R or VTR1000Q (Only HS and HST Series Hood): The hood is designed to work with Thermadors remote ventilator (see list under paragraph Parts Not Included with your Hood). For installati...

[Page 17] Thermador HS-HST-HSB

Page 17 Assembly and Installation of the Duct Covers (HS and HSB Series Hood only): Optional duct covers shown in Fig- ure 14 may be used to fill the space between the hood and ceiling in wall mount installations. 6 and 12 high duct cove...