EverFocus EHD650 Operation Instructions Manual

[Page 1] EverFocus EHD650

EVERFOCUS 1/3” Wide-Dynamic True D/N Rugged Dome Color Camera Operation Instructions Model No. EHD650 Please read this manual first for correct installation and operation. This manual should be retained for future reference. The informa...

[Page 2] EverFocus EHD650

- 2 - TABLE OF CONTENTS 1. PRODUCT OVERVIEW ........................................................................................................................... 3 1.1 MAIN FEATURES ............................................................

[Page 3] EverFocus EHD650

- 3 - 1. PRODUCT OVERVIEW The most technically advanced EHD650 is the newest vandal-resistant Color Rugged Dome Camera from EverFocus Electronics. The Color Rugged Dome Camera can withstand a blow from a 10-pound sledgehammer and has a built-in...

[Page 4] EverFocus EHD650

- 4 - 1.2 Package Contents z Camera Unit x 1 z Mounting Accessory includes: - Screws x 4 - Expanding Screws x 4 - Wrench x 1 z Weather-proof Conduit x 1 z Extension Power Cable and Video cable x 1 z Extension ...

[Page 5] EverFocus EHD650

- 5 - 1.3 Specifications Pickup Device 1/3'' DPS Wide Dynamic range sensor Video Format NTSC or PAL Scanning System NTSC: 525 TV lines, 60 fields/sec PAL: 625 TV lines, 50 fields/sec. Picture Elements 720(H) X 540(V) Horizontal R...

[Page 6] EverFocus EHD650

- 6 - 1.4 Dimensions a. b. ...

[Page 7] EverFocus EHD650

- 7 - 1.5 Hardware Overview Conduit plug setscrew Side conduit hole Back conduit hole Mounting Setscrew Mounting Setscrew Mounting Setscrew Mounting Setscrew OSD mini-joystick Controlle...

[Page 8] EverFocus EHD650

- 8 - 2. INSTALLATION This section covers simple steps and detail installation. Please follow instruction for preventing any unnecessary damage. Simple Steps: 1. Open camera cover. 2. Rotate camera if install on ceiling 3. Drill holes o...

[Page 9] EverFocus EHD650

- 9 - To remove the camera, first unplug the wire connection on the back of the camera. Then loosen the 2 locking screws on the camera base, push the camera base to the right (toward heater direction, as shown in Figure 2), remove the camera fro...

[Page 10] EverFocus EHD650

- 10 - d. Tighten fixing screws and finished 2.2 Mounting Cameras on the Ceiling/Wall a. Mount the base to the wall or ceiling, fix the base by the 4 screws in the accessory pack.(see dimension b for drilling dimension). This dome is weigh...

[Page 11] EverFocus EHD650

- 11 - b. Take off cable conduit if you need to wire cable through side conduit hole. The camera comes with a conduit plug pre-installed in the PF 1/2 conduit hole on the side. The conduit plug can be removed and installed in the back conduit hole...

[Page 12] EverFocus EHD650

- 12 - b. Connect cable conduit to the conduit hole and make it tight. c. Connect the power supply cable (24VAC), video output to the proper connectors. The extension power has 4 colors for Power +(red), - (white) and Video(yellow...

[Page 13] EverFocus EHD650

- 13 - e. Optional connect to Alarm(Please see figure 8 for terminal functions) f. V. Phase adjustment screw is located on the termination board. The vertical phase may require adjustment to synchronize the vertica...

[Page 14] EverFocus EHD650

- 14 - 2.4 Adjust Lens zoom and focus and View a. Adjust Lens zoom and focus(for vari-focal lens models) b. Adjust view angle The camera can be rotated 360° horizontally, 140° vertically and 60°...

[Page 15] EverFocus EHD650

- 15 - 3. HOW TO CONTROL OSD MENU 3.1 Where is OSD Controller Detach the mini-joystick on the side of camera housing. See the following picture. 3.2 General Operation Instruction MAIN MENU SET...

[Page 16] EverFocus EHD650

- 16 - I. Press the SET button for 3 seconds The menu screen will appear on the monitor as the block shown above. II. Using the cursor button Use the cursor button c or d to move the cursor up or down. Use the cursor button e or f to adjust...

[Page 17] EverFocus EHD650

- 17 - 4. MAIN MENU 4.1 Setup ID Camera Menu: Display ID/Camera ID/ID position DISPLAY ID: ON/OFF. The camera ID can be displayed on the screen by setting “ON”. CAMERA ID: When “ON” is selected, use...

[Page 18] EverFocus EHD650

- 18 - ID POSITION: UP-LEFT / UP-CENTER / UP-RIGHT / DWN-LEFT / DWN-CENTER / DWN-RIGHT There are four positions can be chosen to show the CAMERA ID on the screen. Choose an ID position that will not cover the import/critical part of images...

[Page 19] EverFocus EHD650

- 19 - 4.3 WDR (Wide Dynamic Range) EXPO BIAS: MIN -18 ~ 18 MAX Select exposure bias from min. -18 to max. 18. WDR BIAS: MIN –20 ~ 20 MAX The camera offers outstanding Wide-Dynamic Range (WDR). User can manually set the Dynamic R...

[Page 20] EverFocus EHD650

- 20 - WB CONTROL: ATW ATW (Auto Tracking White Balance): This mode can be used within the color temperature range from 2,500°K to 9,500°K (eg, fluorescent light, outdoor, sodium vapor lamp or inside tunnels). WB CONTROL: MANUAL ...

[Page 21] EverFocus EHD650

- 21 - AGC MENU: SET LEVEL from MIN –34 to MAX 43. The more the level of gain increases, the brighter the screen and the level of noise increases as well. PREVIOUS PAGE: Press SET button and you can return to the prev...

[Page 22] EverFocus EHD650

- 22 - 4.7 SYNC SYNC: INTERNAL/LINELOCK SYNC-INTERNAL Internal synchronization. SYNC – LINELOCK Phase adjustment may be necessary in multiple camera installations to prevent picture roll. ...

[Page 23] EverFocus EHD650

- 23 - 4.8 Day/Night Auto/COLOR/B/W DAY/NIGHT: Auto. For automatic switch between day and night mode. C->B 20~35 B->C 0~10 PREVIOUS PAGE: Press SET button and you can return to the previous page. ...

[Page 24] EverFocus EHD650

- 24 - SAVE RESTORE EXIT: RESTORE FACTORY SETTING RESTORE FACTORY SETTING: you will be asked “Are you sure?” before you restore all settings to factory values. Select “YES” to confirm. SW REV: indicating soft...

[Page 25] EverFocus EHD650

- 25 - EverFocus Electronics Corp. Head Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Hsi-Chih, Taipei, Taiwan TEL: +886-2-26982334 FAX: +886-2-26982380 www.everfocus.com.tw USA L.A. Office: 1801 Highland Ave. Unit A Duarte, CA 9101...