TP-LINK TL-SG1048 Installation Manual

[Page 1] TP-Link TL-SG1048

Installation Guide Gigabit Unmanaged Switch TL-SG1048 TL-SG1024/TL-SG1024D TL-SG1016/TL-SG1016D TL-SG1008/TL-SG1008PE Business Networking Solution ...

[Page 2] TP-Link TL-SG1048

...

[Page 3] TP-Link TL-SG1048

I  Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks of th...

[Page 4] TP-Link TL-SG1048

II Related Document  This Installation Guide is also available in PDF on our website. To obtain the latest documentation and product information, please visit the official website: http://www.tp...

[Page 5] TP-Link TL-SG1048

III  Contents Chapter 1 Introduction ——————————— 01 1.1 Product Overview ...................................................................01 1.2 Features ..............................................

[Page 6] TP-Link TL-SG1048

01 Gigabit Unmanaged Switch Introduction   The Gigabit Unmanaged Switch provides you with a high-performance, low-cost, e...

[Page 7] TP-Link TL-SG1048

02 Gigabit Unmanaged Switch Supports IEEE802.3x flow control for full-duplex mode and backpressure for half-• duplex transfer mode Non-blocking switching architecture that forwards and filters packets at full wire-• speed for maximum throughp...

[Page 8] TP-Link TL-SG1048

03 Gigabit Unmanaged Switch Introduction 10/100/1000Mbps RJ45 Port Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding Link/Act LED. The front panel of TL-SG1024 is shown as the fol...

[Page 9] TP-Link TL-SG1048

04 Gigabit Unmanaged Switch The front panel of TL-SG1008 is shown as the following figure. Power 123456 7 8 123456 7 8 Link Act 1000Mbps TL-SG1008 8-Port Gigabit Switch LEDs 10/100/1000Mbps RJ45 Port Front Panel of TL-SG1008Figure 1-6 LEDs LED...

[Page 10] TP-Link TL-SG1048

05 Gigabit Unmanaged Switch Introduction LED Status Indication PoE MAX On (red) The power of all the connected PoE ports is between 118W and 124W. No power may be supplied if additional PDs are connected. Flashing (red) The power of all th...

[Page 11] TP-Link TL-SG1048

06 Gigabit Unmanaged Switch Rear Panel The rear panel of TL-SG1048 is shown as the following figure. Grounding Terminal Power Socket Rear Panel of TL-SG1048Figure 1-8 The rear panel of TL-SG1024 is shown as the following figure. ...

[Page 12] TP-Link TL-SG1048

07 Gigabit Unmanaged Switch Introduction The rear panel of TL-SG1016D is shown as the following figure. Power Socket Grounding Terminal Rear Panel of TL-SG1016DFigure 1-12 The rear panel of TL-SG1008 is shown as ...

[Page 13] TP-Link TL-SG1048

08 Gigabit Unmanaged Switch   Make sure that the package contains the following items. If any of the listed items is damag...

[Page 14] TP-Link TL-SG1048

09 Gigabit Unmanaged Switch Installation Site Requirements  Temperature/Humidity 40℃ 0℃ Please keep a proper temperature and humidity in the equipment room. Too high/low humidity may lead to bad insulation, electricity leakage, mechanica...

[Page 15] TP-Link TL-SG1048

10 Gigabit Unmanaged Switch Lightening Protection Extremely high voltage currents can be produced instantly when lightning occurs and the air in the electric discharge path can be instantly heated up to 20,000℃ . As this instant current is st...

[Page 16] TP-Link TL-SG1048

11 Gigabit Unmanaged Switch Installation  Desktop Installation  To install the device on the desktop, please follow the steps: Set the device on a flat surface strong enoug...

[Page 17] TP-Link TL-SG1048

12 Gigabit Unmanaged Switch Rack Rack InstallationFigure 2-3 Caution: Please set 5~10cm gaps around the device for air circulation.  Please avoid any heavy thing placed on the device.  Please mount devices in sequence from the bottom to t...

[Page 18] TP-Link TL-SG1048

13 Gigabit Unmanaged Switch Lightning Protection   In the actual network environment, you ...

[Page 19] TP-Link TL-SG1048

14 Gigabit Unmanaged Switch Requirements for Cabling Indoors  When cabling indoors, keep a certain distance away from the devices that may cause high-frequency interferences, such as down-conductor cable, powerline, power transformer a...

[Page 20] TP-Link TL-SG1048

15 Gigabit Unmanaged Switch Lightning Protection Cable Pave Way Min Parallel Length (mm) 2~5kVA powerline Parallel cabling 300 One is in the grounded metal raceway or metal pipe 150 The both are in the grounded metal raceway or metal pipe 80 >...

[Page 21] TP-Link TL-SG1048

16 Gigabit Unmanaged Switch Note: The grounding bar and the ground cable are not provided with our product. If needed, please self purchase them. Connecting to the Ground via the Power Supply  If the device is installed in the normal environme...

[Page 22] TP-Link TL-SG1048

17 Gigabit Unmanaged Switch Lightning Protection Grounding Terminal Equipotential Bonding Cable Grounding Bar Ground Cable Equipotential BondingFigure 3-3 When equipotential bonding, please note that the cable should be copper wrapped Kelly ...

[Page 23] TP-Link TL-SG1048

18 Gigabit Unmanaged Switch The port rate of the signal lightning arrester should match the rate of the desired  port on the device. If it is not matched, this signal lighting arrester will not work. Purchase a standard lightning arrester. ...

[Page 24] TP-Link TL-SG1048

19 Gigabit Unmanaged Switch Connection   Connect a Ethernet port of the switch to the computer by RJ45 cable as the following figure show...

[Page 25] TP-Link TL-SG1048

20 Gigabit Unmanaged Switch Note: The figure is to illustrate the application and principle. The power plug you get from the package and the socket in your situation will comply with the regulation in your country, so they may differ from the ...

[Page 26] TP-Link TL-SG1048

21 Gigabit Unmanaged Switch Troubleshooting    The Power LED should be lit up when t...

[Page 27] TP-Link TL-SG1048

22 Gigabit Unmanaged Switch Specifications  Item Content Standards IEEE802.3, IEEE802.3u, IEEE802.3ab, IEEE802.3x IEEE802.3af (for TL-SG1008PE), IEEE802.3at (for TL-SG1008...

[Page 28] TP-Link TL-SG1048

23 Gigabit Unmanaged Switch  For more troubleshooting help, go to: http://www.tp-link.com/en/support/faq  To download the latest Firmware, Driver, Utility an...

[Page 29] TP-Link TL-SG1048

24 Gigabit Unmanaged Switch Poland Tel: +48 (0) 801 080 618 +48 223 606 363 (if calls from mobile phone) Fee: Depending on rate of different carriers. E-mail: [email protected] Service time: Monday to Friday, 09:00 to 17:00. GMT+1 or GMT...

[Page 30] TP-Link TL-SG1048

...

[Page 31] TP-Link TL-SG1048

...

[Page 32] TP-Link TL-SG1048

Website: http://www.tp-link.com E-mail: [email protected] 7106504647 REV5.0.0 ...