Slant/Fin XL-2000 Installation And Operating Instructions Manual

[Page 1] Slant/Fin XL-2000

XXLL--22000000 OIL-FIRED WATER BOILERS/NO. 2 OIL INSTALLATION AND OPERATING INSTRUCTIONS SAFETY WARNING: KEEP BOILER AREA CLEAR AND FREE FROM COM- BUSTIBLE MATERIALS, GASOLINE AND OTHER FLAM- MABLE VAPORS AND LIQUIDS. FAILURE TO ADHERE TO ABOVE SAFET...

[Page 2] Slant/Fin XL-2000

XL-2000 2 XL-20 0.65 91,000 78 68 8 x8x15 6 x 15 83.56 8 11 / 16 4 9 / 16 6¶ 1 1 / 4 25 3 / 8 XL-30H 0.85 119,000 104 90 8 x8x15 6 x 15 86.00 12 3 / 16 6 5 / 16 61 1 / 4 28 7 / 8 XL-30 1.00 140,000 121 105 8 x8x15 6 x 15 85.04 12 3 / 16 6 5 / 16...

[Page 3] Slant/Fin XL-2000

T HE INSTALLATION INSTRUCTIONS IN THIS MANUAL ARE ABBREVIATED. SEE THE FRONT COVER OF THIS MANUAL FOR REFERENCES TO CODES AND STAN- DARDS. BOILER LOCATION Provide a level, solid foundation for the boiler. Location should be near the chimney so that t...

[Page 4] Slant/Fin XL-2000

tion, heavy sooting and health hazards. Any oil-fired boiler must have a steady draft* and an ample supply of combustion air at all times during firing. If air supply or chimney draft* is unreliable, CO 2 and overfire draft* will change unpredictably...

[Page 5] Slant/Fin XL-2000

XL-2000 5 Figure 3a. Appliances located in confined spaces. Air from inside the building. See Table 2 (2.3). Figure 3b. Appliances located in confined spaces. Air from out- doors. See Table 2 (2.4). Figure 3c. Appliances located in confined spaces. A...

[Page 6] Slant/Fin XL-2000

XL-2000 6 The opening size recommendation just given is for guidance only. It is the installer’s responsibility to provide air for combus- t ion and ventilation to all appliances, under all operating con- ditions, for each installation. See NFPA 31...

[Page 7] Slant/Fin XL-2000

DOMESTIC HOT WATER For Indirect-fired storage water heater application, see S lant/Fin publication WH-10, Sizing Guide WH-SG and Installation manual WH-40. The installation manual includes several control systems and relay centers for space and domes...

[Page 8] Slant/Fin XL-2000

smoke and dry soot formation in the fire box. F. If smoke reading is satisfactory, but CO 2 can not be increased to a satisfactory level (12%) or overfire draft of 0 .02" W.C. can not be obtained, check for proper sealing between sections, betwe...

[Page 9] Slant/Fin XL-2000

6. Use the flue brush to clean the pinned flueways b etween the sections.† A wire brush may be used to remove any carbon accumulation that may have d eveloped in the combustion chamber. Vacuum the loose soot and debris from the boiler. 7. Inspect t...

[Page 10] Slant/Fin XL-2000

XL-2000 10 ...

[Page 11] Slant/Fin XL-2000

BURNER DATA—CARLIN BURNERS FOR PACKAGED BOILERS ONLY XL-2000 11 XL-20 99-FRD 0.65 0.65 70° A DELAVAN 100 0 50 Closed 71399-00F-XL-20 0.65 70° W DELAVAN 100 0 50 Closed XL-30 99-FRD 1.00 1.00 70° A DELAVAN 100 2 80 Closed 71399-00F-XL-30 1.15 1.0...

[Page 12] Slant/Fin XL-2000

XL-2000 12 BURNER DATA—BECKETT BURNERS FOR PACKAGED BOILERS ONLY XL-20 (4) AFG F0 0.65 0.65 80° A DELAVAN 100 7 Blank/Closed 3 3 / 8 SF2201 XL-30H AFG F3 0.85 0.85 70° W DELAVAN 100 6 Blank/Closed 2 3 / 4 SF2204 XL-30 AFG F3 1.00 1.00 80° W DELA...

[Page 13] Slant/Fin XL-2000

BURNER DATA - RIELLO BURNERS FOR PACKAGED BOILERS ONLY (RIELLO R-40 SERIES W/SHORT TUBE) † Air shutter and head settings shown are approximate ONLY. See START-UP page 7 NOTE: For proper insertion into combustion chamber see figure 8 XL-2000 13 BOIL...

[Page 14] Slant/Fin XL-2000

XL-2000 14 BURNER DATA - RIELLO (continued) REGULATION OF THE TURBULATOR AND AIR SHUTTER F OR PROPER COMBUSTION Turbulator Setting 1. Loosen nut, 1, then turn the screw, 2, until the index marker, 3, is aligned with the correct index number. 2. Reti...

[Page 15] Slant/Fin XL-2000

SLANT/FIN CORPORATION, Greenvale, N.Y. 11548 • Phone: (516) 484-2600 F AX: (516) 484-5921 • Canada: Slant/Fin L TD/LTEE, Mississauga, Ontar io www.slantfin.com ©Slant/Fin Corp. 1996. ...