Makita DDF470 Instruction Manual

[Page 1] Makita DDF470

1 ENGLISH (Original instructions) INSTRUCTION MANUAL IMPORTANT: Read Before Using. Cordless Driver Drill DDF470 DDF480 013955 ...

[Page 2] Makita DDF470

2 ENGLISH (Original instructions) SPECIFICATIONS Model DDF470 DDF480 Steel 13 mm 13 mm Wood 38 mm 38 mm Wood screw 10 mm x 90 mm 10 mm x 90 mm Capacities Machine screw M6 M6 High (2) 0 - 1,550 0 - 1,550 No load speed (min -1 ) Lo...

[Page 3] Makita DDF470

3 ENH101-16 For European countries only EC Declaration of Conformity We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Cordless Driver Drill Model No./ Type: DDF470, ...

[Page 4] Makita DDF470

4 jewellery or long hair can be caught in moving parts. 16. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust- related ...

[Page 5] Makita DDF470

5 WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause seri...

[Page 6] Makita DDF470

6 FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 1 2 3 013962 CAUTION: �...

[Page 7] Makita DDF470

7 LED indicator status Remaining battery capacity About 50% or more About 20% - 50% About less than 20% 013980 NOTE: • The LED display goes off approximately one minute after releasing the switch trigger to save the battery power. To check...

[Page 8] Makita DDF470

8 Speed change 1 013959 CAUTION: • Always set the speed change lever fully to the correct position. If you operate the tool with the speed change lever positioned halfway between the "1" side and "2" side, the tool ma...

[Page 9] Makita DDF470

9 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit or drill bit 1 013956 Turn the sleeve counterclockwise...

[Page 10] Makita DDF470

10 Drilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a center-punch and hammer at the point to be drilled. Place the point of the bit in the indentation and start drilling. Use a cutting lubricant...

[Page 11] Makita DDF470

11 ...

[Page 12] Makita DDF470

12 Makita Corporation Anjo, Aichi, Japan www.makita.com 885224A223 ...