ElmoTech 1TRACK Installation And Operation Manual

[Page 1] ElmoTech 1TRACK

Installation and Operation Guide ...

[Page 2] ElmoTech 1TRACK

Information in this documentation is subject to change without notice and does not represent a commitment on part of Elmo-Tech Ltd. The software described in this document is subject to the license agreement that is included with the product, whi...

[Page 3] ElmoTech 1TRACK

i Table of Contents 1 Introduction.................................................................... 1 Components..................................................................... 2 LED Indicators..........................................

[Page 4] ElmoTech 1TRACK

1TRACK Installation and Operation Guide ii List of Figures Figure 1 1TRACK Components ................................................2 Figure 2 1TRACK LED Indicators .............................................3 ...

[Page 5] ElmoTech 1TRACK

1 1 Introduction The 1TRACK wearable tracking unit was designed specifically for Offender monitoring operations. With security redundancies and anti-tamper mechanisms built-in across the platform, the 1TRACK unit provides a trustworthy an...

[Page 6] ElmoTech 1TRACK

1TRACK Installation and Operation Guide 2 Components The 1TRACK unit features the following components: Figure 1 1TRACK Components LED Indicators The 1TRACK unit features three LED indicators on its top. Each LED can flash green or red ...

[Page 7] ElmoTech 1TRACK

1 Introduction 3 Figure 2 1TRACK LED Indicators PWR The PWR LED indicates the condition of the 1TRACK unit battery. f Flashing Green – The 1TRACK unit is activated or is in the process of being activated, and the battery does n...

[Page 8] ElmoTech 1TRACK

1TRACK Installation and Operation Guide 4 f Solid Red – The 1TRACK unit is connected to the charger and is not yet fully charged. The 1TRACK unit should not be disconnected from the charger. f Off – While the 1TRACK unit is on and acti...

[Page 9] ElmoTech 1TRACK

5 2 Installing the 1TRACK Unit Installing the 1TRACK unit involves: f Collecting the appropriate installation equipment and tools f Verifying that the Offender is registered in the E3-MWS software f Activating the unit Installation E...

[Page 10] ElmoTech 1TRACK

1TRACK Installation and Operation Guide 6 Installation Tools Installation also requires the following tool: f Strap cutter Verifying Offender Information in the E3-MWS Verify the following Offender details in the E3-MWS software applicati...

[Page 11] ElmoTech 1TRACK

2 Installing the 1TRACK Unit 7 2. Into each bracket on the back of the 1TRACK unit, insert a tamper plug: a. Loosely place the tamper plug into the hole in the bracket. b. Place your finger over the right side of the tamper plug...

[Page 12] ElmoTech 1TRACK

1TRACK Installation and Operation Guide 8 5. Place the 1TRACK unit on the Offender’s leg, just above the ankle bone. 6. Wrap the strap around the Offender’s leg and determine the point on the strap that lines up with the correspond...

[Page 13] ElmoTech 1TRACK

2 Installing the 1TRACK Unit 9 8. Set the 1TRACK unit on a flat surface with the Activation button facing upwards and lay the strap flat along the surface. 9. Place the second pin tray on a flat surface and keeping the strap orien...

[Page 14] ElmoTech 1TRACK

...

[Page 15] ElmoTech 1TRACK

11 3 Status Alerts The following sections provide a reference to the various status alerts that can be generated by the 1TRACK unit, and their indications. Low Battery The 1TRACK unit’s battery is running low and needs to be charged. ...

[Page 16] ElmoTech 1TRACK

1TRACK Installation and Operation Guide 12 Motion No GPS The 1TRACK unit has accumulated 10 minutes of Offender motion in a 60 minute period without receiving a GPS signal. This status is indicated by the following: f The device initially ...

[Page 17] ElmoTech 1TRACK

3 Status Alerts 13 Geographic Zone Alerts The Offender has violated one or more zone restrictions: f Inclusion Zone – Geographic areas like home or work in which the Offender is required to be during prescheduled intervals. Being ou...

[Page 18] ElmoTech 1TRACK

...

[Page 19] ElmoTech 1TRACK

15 4 Dismantling the 1TRACK Unit Dismantling the 1TRACK unit involves: f Performing an End of Service, when applicable f Removing, deactivating, and packing the 1TRACK unit Before Dismantling Before leaving the monitoring center, check...

[Page 20] ElmoTech 1TRACK

1TRACK Installation and Operation Guide 16 Removing the 1TRACK Unit To remove the 1TRACK unit: 1. Cut the strap using the strap cutter and remove the 1TRACK unit from the Offender’s leg. 2. Using the flathead screwdriver, push on t...

[Page 21] ElmoTech 1TRACK

4 Dismantling the 1TRACK Unit 17 4. On one end of the strap, use the screwdriver to press down the latch attached to the pin tray. 5. While keeping the latch depressed, pull the strap with the attached pin tray out of the brac...

[Page 22] ElmoTech 1TRACK

...

[Page 23] ElmoTech 1TRACK

19 5 Cleaning the 1TRACK Unit Cleaning the 1TRACK unit is recommended to keep the unit functional and in good working order. To clean the 1TRACK unit: 1. Spray the unit with 3M TM Citrus Base cleaner, or an alcohol based equivalent. O...