Nady Systems UHF-7 Owner's Manual

[Page 1] Nady Systems UHF-7

OWNER'S MANUAL Nady Wireless Systems are type accepted under FCC rules parts 90, 74 and 15. The device complies with RSS-210 of Industry & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause ha...

[Page 2] Nady Systems UHF-7

CONTENTS ...........................................................................................2 INTRODUCTION ....................................................................................2 USING THIS MANUAL...................................

[Page 3] Nady Systems UHF-7

10 3 UHF-7 RECEIVER • Unprecedented value in a full-featured single-channel UHF wireless mic system — with interference-free operation in any application or locale on select UHF frequencies within separate bands 902-928 and 944-952 MHz • Half-...

[Page 4] Nady Systems UHF-7

4 1. Rackmounting the Receiver There are 2 options available for rackmounting the UHF-7 receiver: singly or side-by- side with another UHF-7 Series receiver. a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of the receiver (...

[Page 5] Nady Systems UHF-7

8 1. Snap open the BATTERY DOOR (22) and insert a fresh 9V alkaline battery into the BATTERY COMPARTMENT (23), observing the correct polarity. Fresh alkaline batteries can last up to 10 hours in use, but in order to ensure optimum performance, it is ...

[Page 6] Nady Systems UHF-7

7 1. Unscrew the BATTERY COMPARTMENT COVER (16) and remove, exposing the BATTERY HOLDER (17). Insert a fresh 9V ALKALINE BATTERY (18), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is scr...