Xantech 480-95 Install Manual

[Page 1] Xantech 480-95

08905099B - 1 - INSTALLATION INSTRUCTIONS 480-95 Plasma Friendly Dinky Link IR Receiver DESCRIPTION The 480-95 is a Plasma Friendly version of the 480-00 series Dinky Link IR receivers. It is specifically designed to have greater...

[Page 2] Xantech 480-95

08905099B - 2 - SPECIFICATIONS: INSTALLATION This unit is meant to be interfaced to Xantech Connecting Blocks, such as CB12, 789-44, 791-44, etc. PLACEMENT Placement of the IR Receiver does matter when used in the presence of a...

[Page 3] Xantech 480-95

08905099B - 3 - Note: Plasma interference can be reflected off of any item it comes into contact with approx. 3 feet from the front of the display. Keeping this in mind, make sure that the 480-95 is free of any obstruction that might re...

[Page 4] Xantech 480-95

08905099B - 4 - ADVANCED WIRING CONFIGURATION 480-95 may also be used in conjunction with other Xantech IR Receivers by simply wiring in parallel on a Connecting Block such as the 791-44 Amplified Block as shown in the figure below. ...

[Page 5] Xantech 480-95

08905099B - 5 - IR Troubleshooting Guide NOTE: Due to the many variables in a given installation, the troubleshooting countermeasures you will have to take may vary from job to job. Each installation is different due to the number ...

[Page 6] Xantech 480-95

08905099B - 6 - Symptom #2: TB LED on IR Receiver (and/or Emitters) Dimly lit or flickering Cause: Solution 1. Signal and ground wires are reversed or shorted either at the connecting block or IR receiver. Recheck ...

[Page 7] Xantech 480-95

08905099B - 7 - Symptom #3: TB LED on IR Receiver (and/or Emitters) on solid Cause: Solution 1. Plasma Interference Use a 490-90 Plasma 'Friendly' Receiver. If already using a 490-90 unit, please n...

[Page 8] Xantech 480-95

08905099B - 8 - Symptom #4: TB LED on IR Rec. blinks but 283M or 286M 'Blink' style Emitters do not Cause: Solution 1. There may be a short, such as a staple driven through the Signal and GND wires o...

[Page 9] Xantech 480-95

08905099B - 9 - Symptom 6: Emitters function but some (or all) components do not respond. Cause: Solution 1. Emitter placement is incorrect. Reposition the Emitter so that it is directly over the components sensor wi...

[Page 10] Xantech 480-95

08905099B - 10 - Symptom #7: Absolutely No Functionality (How to determine which component is at fault) Step: Component to Test Instructions 1. Verify Power Supply With a Multimeter, measure the DC Voltage of the supply w...

[Page 11] Xantech 480-95

08905099B - 11 - 4. Verify IR Receiver. Remove the power supply from the connecting block and all Emitters from the output. Place a jumper wire on the connecting block between IR Signal and GND. Reconnect the Power Supply. With a k...