System Sensor INNOVAIR DH100LP Installation And Maintenance Instructions Manual

Download or browse on-line these Installation And Maintenance Instructions Manual for System Sensor INNOVAIR DH100LP Smoke Alarm.

System Sensor INNOVAIR DH100LP Manual Information:

This manual for System Sensor INNOVAIR DH100LP, given in the PDF format, is available for free online viewing and download without logging on. The guide contains 8 pages, and the size of the file at download is . The document type is Installation And Maintenance Instructions Manual.

Download Manual

More Manuals:

In case you failed to obtain relevant information in this document, please, look through related operating manuals and user instructions for System Sensor INNOVAIR DH100LP. Just click one of the links below to go to the selected manual:

Summary of Contents:

[Page 1] System Sensor INNOVAIR DH100LP

D200-15-00 1 I56-0083-07R DH100LP Air Duct Smoke Detector with Ext...

[Page 2] System Sensor INNOVAIR DH100LP

[5.2] Drill The Mounting Holes Remove the paper backing from the mounting template supplied. Affix the template to the duct at the desired mounting location. Make sure the template lies flat and smooth on the duct. Center p...

[Page 3] System Sensor INNOVAIR DH100LP

the inlet hole on the opposite side of the duct to allow for moisture drainage. If the tube is shorter than the width of the air duct, install the end cap into the sampling tube as shown in Figure 4. Sampling tubes over 3 ft. long must be support...

[Page 4] System Sensor INNOVAIR DH100LP

[5.4.3] Modifications of Sampling Tubes There may be applications where duct widths are not what is specified for the installation. In such cases, it is permis- sible to modify a sampling tube that is longer than neces- sary to span the duct width. ...

[Page 5] System Sensor INNOVAIR DH100LP

For signal wiring, (the wiring between interconnected detectors or from detectors to auxiliary devices), it is usu- ally recommended that single conductor wire be no smaller than 18 gauge. The duct smoke detector terminals accom- modate wire ...

[Page 6] System Sensor INNOVAIR DH100LP

D200-15-00 6 I56-0083-07R DETECTOR BOARD 7 6 4 (+) IN (+) OUT (+)...

[Page 7] System Sensor INNOVAIR DH100LP

Test — The trouble condition can be caused inten- tionally to verify correct operation of the sys- tem. Remove the detector board to cause a trouble condition locally and at the system ...

[Page 8] System Sensor INNOVAIR DH100LP

[9] Model DH100LP Air Duct Smoke Detector Specifications Operating Temperature: +32° to +131° F 0° to +55° C Storage Temperature: –22° to +158° F ...