KAM Laser Tri260 SD FScan Instruction Manual

Download or browse on-line these Instruction Manual for KAM Laser Tri260 SD FScan Flood Light.

KAM Laser Tri260 SD FScan Manual Information:

This manual for KAM Laser Tri260 SD FScan, given in the PDF format, is available for free online viewing and download without logging on. The guide contains 8 pages, and the size of the file at download is . The document type is Instruction Manual.

Download Manual

Summary of Contents:

[Page 1] KAM Laser Tri260 SD FScan

Laser Tri260 SD FScan 260mW DMX RGY animation laser with SD card interface Fast scanning DMX RGY animation laser with SD card interface Includes FREE pre-programmed SD card 10 channel ...

[Page 2] KAM Laser Tri260 SD FScan

INTRODUCTION Thank you for purchasing the Kam Laser Tri260 SD Fscan. To optimise the performance of this product, please read these operating instructions carefully to familiarize yourself with the basic operations of this unit. The KAM Laser ...

[Page 3] KAM Laser Tri260 SD FScan

REAR PANEL FUNCTION TABLE: 1 MIC Audio in 2 VOLUME Volume sensitivity 3 Mode Message centre Indicating the state of SD card controlling system 4 SD Card Controlling Settings Used to set some important parameters for...

[Page 4] KAM Laser Tri260 SD FScan

Function mode setting Master/Slave settings, No DMX Controller For master/slave mode, put the 2nd switch to ON position and it works as slave. DMX Control mode For DMX mode, the 10th dip switch must be ON. Then, set the DMX base add...

[Page 5] KAM Laser Tri260 SD FScan

DMX channels assignment: Channel DMX512 VALUE FUNCTION 1.Control Mode 0-63 Sound control (3-10ch not available) 64-149 Auto mode (3-10chnot available) 150-199 DMX control 200-255 Auto mode F I R S T P A T T E R ...

[Page 6] KAM Laser Tri260 SD FScan

Press “FUNC” to exit this parameter. The value is stored automatically. All values are stored and activated when you exit the parameter input by pressing “FUNC parameter. The value is stored automatically. Without changing anything in the ...

[Page 7] KAM Laser Tri260 SD FScan

IMPORTANT WARNING When you change size by the use of DMX-control, a fader position of 0 (minimum) can cause a standing single point laser beam. This can be a dangerous condition! DMX only allows a refresh rate of 50 Hz. Moving a control fader fa...

[Page 8] KAM Laser Tri260 SD FScan

PC MODE Put the mode switch to PC MODE position and then connect the PC ILDA output interface to the ILDA IN connector on the rear panel using a standard and easily available (not supplied), ILDA connecting cable. If you want to make your own cabl...