Atomik 60A Instruction Manual

[Page 1] Atomik 60A

INSTRUCTION MANUAL AND TUNING GUIDE www.atomik-rc .com 18002 Atomik RC™ 14028 N. Ohio Street Rathdrum, Idaho 83858 USA Australia PO Box 7325 Alexandria, NSW 2015 © Copyright 2013 Atomik RC www.atomik-rc.com www.facebook.com/AtomikRC www.twitter.c...

[Page 2] Atomik 60A

2 ATOMIK-RC.COM COPYRIGHT © 2013 ATOMIK RC 3 SAFETY PRECAUTIONS SAFETY PRECAUTIONS SPECIFICATIONS SPECIFICATIONS • Never swim out to retrieve an R/C boat that has stalled in the water. If you are going into the water, use a small boat or ka...

[Page 3] Atomik 60A

2 3 ATOMIK-RC.COM 18002 Thank you for purchasing your new Atomik™ P1 36" RTR Electric Boat. This RTR Electric Boat was designed with both beginning R/C Boat hobbyists and die hard boat enthusiasts in mind. Racers will love the adjustability a...

[Page 4] Atomik 60A

4 ATOMIK-RC.COM COPYRIGHT © 2013 ATOMIK RC 5 4 AA BATTERIES 1521 AA Rechargeable NiMH ECOAA8 AA Alkalines CHARGER 0657 Venom Pro Charger Thin CA Glue Curved Scissors Needle Nosed Pliers Side Cutters Thread Lock LiPO BATTERY PACKS RECOMMENDED BAT...

[Page 5] Atomik 60A

4 5 ATOMIK-RC.COM 18002 STEP #1. Enter the programming mode. Switch on the transmitter. Move the throttle trigger to the Full throttle position and then connect the battery pack to the ESC. Wait for 2 seconds, the motor emits “Beep-Beep” tone. ...

[Page 6] Atomik 60A

6 ATOMIK-RC.COM COPYRIGHT © 2013 ATOMIK RC 7 Slide the prop onto the drive shaft making sure to align the notch with the drive dog. Use the supplied lock nut to secure the prop to the propshafts. Use caution when installing the prop as it may have...

[Page 7] Atomik 60A

6 7 ATOMIK-RC.COM 18002 1. Slide control rod through pivot block. 2. Apply thread lock and tighten the set screw. 3. Make sure the servo is centered before tightening set screw. INSTALLING THE RUDDER INSTALLING THE RUDDE...

[Page 8] Atomik 60A

8 ATOMIK-RC.COM COPYRIGHT © 2013 ATOMIK RC 9 Secure the hatch by sliding the front pin into the hole at the front of the hull opening. The Hatch should drop easily down so that the magnets hold the hatch in alignment. To waterproof the hatch, use s...

[Page 9] Atomik 60A

8 9 ATOMIK-RC.COM 18002 See page 6. Loosen the drive using a pair of needle nose pliers and a 2.5mm Hex Driver. Adjust the drive up or down to change the running angle of the boat. Use the etched angle markings on the drive as a guide. The alignm...

[Page 10] Atomik 60A

10 ATOMIK-RC.COM COPYRIGHT © 2013 ATOMIK RC 11 7 8 BOAT MAINTENANCE BOAT MAINTENANCE DRIVE LINE 1. Remove the prop. 2. Loosen the motor coupler set screws for the flex cable. 3. Slide the flex cable out of the drive. 4. Lubricate the flex cab...

[Page 11] Atomik 60A

10 11 ATOMIK-RC.COM 18002 BOAT MAINTENANCE BOAT MAINTENANCE DRIVE LINE 1. Remove the prop. 2. Loosen the motor coupler set screws for the flex cable. 3. Slide the flex cable out of the drive. 4. Lubricate the flex cable with marine grease. 5. ...

[Page 12] Atomik 60A

12 ATOMIK-RC.COM COPYRIGHT © 2013 ATOMIK RC 13 Problem Cause Fix Speed Control does not operate. 1. Transmitter and/or receiver is not switched on. 1. Switch on. 2. Batteries are not fully charged. 2. Charge batteries. 3. Improper radio installation...

[Page 13] Atomik 60A

12 13 ATOMIK-RC.COM 18002 13 SETUP NOTES SETUP NOTES ...

[Page 14] Atomik 60A

14 ATOMIK-RC.COM COPYRIGHT © 2013 ATOMIK RC 15 BATTERY BOAT WEIGHT AND SETUP SPECS SETUP NOTES SETUP NOTES MOTOR & ESC SERVO PROP & DRIVE ANGLES CG RANGE 210-230mm mm mm mm ...

[Page 15] Atomik 60A

14 15 ATOMIK-RC.COM 18002 BATTERY BOAT WEIGHT AND SETUP SPECS SETUP NOTES SETUP NOTES MOTOR & ESC SERVO PROP & DRIVE ANGLES CG RANGE 210-230mm mm mm mm ...

[Page 16] Atomik 60A

INSTRUCTION MANUAL AND TUNING GUIDE www.atomik-rc .com 18002 Atomik RC™ 14028 N. Ohio Street Rathdrum, Idaho 83858 USA Australia PO Box 7325 Alexandria, NSW 2015 © Copyright 2013 Atomik RC www.atomik-rc.com www.facebook.com/AtomikRC www.twitter.c...