Advent ADV38FR Installation Manual

Download or browse on-line these Installation Manual for Advent ADV38FR Car Receiver, Monitor.

Advent ADV38FR Manual Information:

This manual for Advent ADV38FR, given in the PDF format, is available for free online viewing and download without logging on. The guide contains 12 pages, and the size of the file at download is . The document type is Installation Manual.

Download Manual

More Manuals:

In case you failed to obtain relevant information in this document, please, look through related operating manuals and user instructions for Advent ADV38FR. Just click one of the links below to go to the selected manual:

Summary of Contents:

[Page 1] Advent ADV38FR

Installation Guide ADV38FR 10.2” OVERHEAD LCD MONITOR WITH DVD PLAYER ON OFF AUTO ...

[Page 2] Advent ADV38FR

Important Notice An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD p...

[Page 3] Advent ADV38FR

MATERIALS INCLUDED IN THIS PACKAGE: 1) 10.2" TFT LCD Overhead Monitor With DVD Player - (1pc) 2) 12 Pin Power / Signal Harness (P/N 112-3483) - (1pc) 3) 2 Pin Power Wire Harness With Choke (P/N 112...

[Page 4] Advent ADV38FR

catch catch Begin by hooking area “A” (above) over the dome light and slide the cover over the pod. The cover will snap in place. Place the pod on a soft surface to avoid damaging the plastic. Open the screen and hook the two tabs “B” on the ...

[Page 5] Advent ADV38FR

2 3 5 Work on a soft surface to avoid damaging the plastic. Insert the supplied pry tool between the Housing and Snap On Cover (Shroud), then press the pry tool to release the Snap On Cover (Shroud). Insert the supplied pry tool between the Housing ...

[Page 6] Advent ADV38FR

VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good ground generally, these wires can be found at the ignition switch or fuse- box. 2) The mounting method...

[Page 7] Advent ADV38FR

TRIM RING INSTALLATION: Note: This page only covers special installation considerations for thick trim ring installation. If the video monitor is to be installed in a vehicle with the thick trim ring, it may need to be trimmed to fit the contour of ...

[Page 8] Advent ADV38FR

TRIM RING INSTALLATION: Supplied screws as below use for install Trim Ring to unit. Please refer illustration below. A) #4 x 5/16 Self Tapping Screws (1pc) B) #4 x 7/16 Self Tapping Screws (3pcs) C) Screws ISO 3 x 8mm Long (5pcs) A B BB C C C C C Roo...

[Page 9] Advent ADV38FR

1) Make the connections to the vehicle for the 12 pin wiring harness. 2) Connect power harness to vehicles electrical system by tapping into an accessory hot line and a good ground. 3) Connect the 12 pin harness to the mating connector ...

[Page 10] Advent ADV38FR

CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of dome light circuits used, positive or negative switched system. Positive switched sys...

[Page 11] Advent ADV38FR

Red / black - Lamp on To 12 pin connector To constant To constant Black / red - Lamp common Purple / brown - Lamp Auto Factory Door ajar switch or Body Control computer Troubleshooting: SYMPTOM: REMEDY: No power at Video Monitor Verify +12 VDC on Red...

[Page 12] Advent ADV38FR

© 2010 ADVENT, 150 Marcus Blvd. Hauppauge, NY 11788 128-8817 ...