Kenwood CK 700 A Instructions For Use Manual

[Page 1] Kenwood CK 700 A

DUAL FUEL COOKER model CK 700 A Instructions for use - Installation advice Before operating this cooker, please read these instructions carefully GB ...

[Page 2] Kenwood CK 700 A

2 CONTENTS Page Number Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Important precautions & recommendations . . . . . . . . . . . . . . . . . . . . Cooking hob . . . . . . . . . . . . ....

[Page 3] Kenwood CK 700 A

3 Important: This appliance is designed and manufactured solely for the cooking of domestic (house- hold) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment. This appliance guarante...

[Page 4] Kenwood CK 700 A

4 FIRST USE OF THE OVEN/S It is advised to follow these instructions: • Furnish the interior of the oven/s as described at chapter “Cleaning and maintenance”. • Insert shelf and tray. • Switch on the empty oven/s on max to eliminat...

[Page 5] Kenwood CK 700 A

5 del), before disposing of it, it is recommended that it be made inoperative in an appropriate manner in accordance to health and environmental protection regulations, ensuring in parti- cular that all potentially hazardous parts be made harmless, ...

[Page 6] Kenwood CK 700 A

6 GAS BURNERS 1. Auxiliary burner (A) 1,00 kW 2. Semi-rapid burner (SR) 1,75 kW 3. Rapid burner (R) 3,00 kW 4. Triple-ring burner (TR) 3,50 kW Fig. 1.1 1 - COOKING HOB 1 2 2 4 3 Notes: • The electric ignition is incorporated...

[Page 7] Kenwood CK 700 A

7 123456789 10 11 CONTROLS DESCRIPTION 1. Front right rapid burner control knob 2. Rear right semi-rapid burner control knob 3. Central triple-ring burner control knob 4. Rear left semi-rapid burner control knob 5. Front left auxiliary burner ...

[Page 8] Kenwood CK 700 A

8 Caution! The cooking hob becomes very hot during operation. Keep children well out of reach. N.B. When the cooker is not being sed, set the gas knobs to their closed positions and also close the cock val- ve on the gas bottle or the main gas su...

[Page 9] Kenwood CK 700 A

9 CHOICE OF THE BURNER On the control panel, near every knob the- re is a diagram that indicates which burner is controlled by that knob. The suitable burner must be chosen ac- cording to the diameter and the capacity used. As an indication, the ...

[Page 10] Kenwood CK 700 A

10 CORRECT USE OF TRIPLE RING BURNER Theat-bottomedpansaretobeplaceddirectlyontothepan-support. To use the WOK you need to place the proper stand in order to avoid any faulty operation of the triplering burner (Figs....

[Page 11] Kenwood CK 700 A

11 GENERAL FEATURES Fan cooking is more economical and quicker than cooking in a conventional oven. The moving hot air surrounds the food and penetrates it more quickly than in a conventio- nal oven. The oven is equipped with a circular element (2200...

[Page 12] Kenwood CK 700 A

12 SWITCH / TEMPERATURE SELECTOR Rotate the knob clockwise to set the oven for one of the following functions: Off Only the oven fan is on. The fan operates without the heating element, this function can be used for defrosting. 50 to 250 The oven l...

[Page 13] Kenwood CK 700 A

13 COOKING ADVICE STERILIZATION Sterilization of foods to be conserved, in full and hermetically sealed jars, is done in the following way: a. Set the selector knob to position 185 °C and preheat the oven. b. Fill the dripping pan with hot water....

[Page 14] Kenwood CK 700 A

14 GENERAL FEATURES The convection oven is equipped with 3 electrical heating elements: • 2 elements (upper and lower) for normal oven cooking; • 1 grill element, on the top of the oven, for grilling which must be done with the oven door c...

[Page 15] Kenwood CK 700 A

15 THERMOSTAT KNOB (Fig. 5.2) This only sets the cooking temperature and does not switch the oven on. Rotate clockwise until the required temperature is reached (from 50° C to MAX). The light between the thermostat and the function selector will ill...

[Page 16] Kenwood CK 700 A

16 LOWER HEATING ELEMENT In this position only the lower element is switched on. Heat is distributed by natural con- vection. The thermostat can be set between 50 and 150°C; higher temperatures are not available. Recommended for: This mode is pa...

[Page 17] Kenwood CK 700 A

17 6 - CLOCK AND TIMER WITH “TOUCH-CONTROL” KEYS (BOTTOM MAIN OVEN ONLY) KEYS: + and – Touched simultaneously (for more than 2 seconds): • setting the clock; • setting the timer volume (by touching once, along with the “M...

[Page 18] Kenwood CK 700 A

18 “TOUCH-CONTROL” KEYS The“touch-control”keysshallbeoperatedbythengers(justbytouchingthekey). Whenusingtouchcontrolsitisbesttousetheballofyourngerrather�...

[Page 19] Kenwood CK 700 A

19 AUTOMATIC COOKING (BOTTOM MAIN OVEN ONLY) Use automatic cooking to automatically turn the oven on, cook, and then turn the oven off. 1. Check the clock shows the correct time. 2. Select the function and temperature (function and temperature kno...

[Page 20] Kenwood CK 700 A

20 7 - COOKING GUIDE Temperature and times given are approximate, as they will vary depending on the quality and amount of food being cooked. Remember to use ovenproof dishes and to adjust the oven temperature during cooking if necessary. Food Te...

[Page 21] Kenwood CK 700 A

21 8 - CLEANING AND MAINTENANCE GENERAL ADVICE • Before you begin cleaning, you must ensure that the appliance is switched off. • When the appliance is not being used, it is advisable to keep the gas tap clo- sed. • The periodical...

[Page 22] Kenwood CK 700 A

22 BURNERS AND PAN SUPPORTS These parts can be removed and cleaned with appropriate products. Aftercleaning,theburnersandtheirame spreaders must be well dried and correctly replaced. It is very important to check that the bu...

[Page 23] Kenwood CK 700 A

23 S F C T Fig. 8.1 Fig. 8.2 A B T S Fig. 8.3 Fig. 8.4 Fig. 8.5 ...

[Page 24] Kenwood CK 700 A

24 ASSEMBLING AND DISMANTLING OF THE SIDE RUNNER FRAMES • Assemble the wire racks to the oven walls using the 2 screws (Figs. 8.6a - 8.6b). • Slide the tray and rack into the runners (Figs. 8.7a - 8.7b).  Therackmustbette...

[Page 25] Kenwood CK 700 A

25 REPLACING THE OVEN LIGHT BULB WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric shock. • Let the oven cavity and the heating elements to cool down. • Switch off the electrical s...

[Page 26] Kenwood CK 700 A

26 TOP OVEN DOOR REMOVING THE OVEN DOOR The oven door can easily be removed as fol- lows: • Open the door to the full extent (g. 8.9a). • Open the lever A completely on the left andrighthinges(g.8....

[Page 27] Kenwood CK 700 A

27 Fig. 8.10a Fig. 8.10c B A Fig. 8.10b Fig. 8.10 TOP OVEN DOOR REMOVING THE INNER PANE OF GLASS The oven door has two panes. To clean these, you need to remove the inner pane. 1. Lock the door open: • Fullyopentheovendoor�...

[Page 28] Kenwood CK 700 A

28 D E F E F H H Fig. 8.11c Fig. 8.11b Fig. 8.11a A Fig. 8.11 TOP OVEN DOOR REPLACING THE INNER PANE OF GLASS 1. Make sure the door is locked open (see previous page). 2. Replace the inner pane: • Check that the four rubber pads are ...

[Page 29] Kenwood CK 700 A

29 BOTTOM OVEN DOOR Note: The oven door should only be re- moved by an authorised service agent. Removal of the oven door by a non- authorised person will invalidate the guarantee. BOTTOM OVEN DOOR REMOVING THE INNER PANE OF GLASS When removing a...

[Page 30] Kenwood CK 700 A

30 BOTTOM OVEN DOOR REPLACING THE INNER PANE OF GLASS To replace the inner pane of the door ope- rate as follows: • Check that the four rubber pads are in place (D in Fig. 8.14). • Check that you are holding the pane thecorrectway....

[Page 31] Kenwood CK 700 A

31 IMPORTANT • The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi commercial or communal environment.  The appliance may be installed in a kitchen, Kitchen/diner or a bed sitting r...

[Page 32] Kenwood CK 700 A

32 9 - INSTALLATION 200 mm 650 mm 500 mm 450 mm Fig. 9.1 This cooker has class “2/1” overheating protection so that it can be installed next to a cabinet. If the cooker is installed adjacent to furniture which is higher than the gas hob cookto...

[Page 33] Kenwood CK 700 A

33 0 + 5 mm A Before installing the cooker level the appliance by screwing or unscrewing the four adju- stablefeetttedbelow. WARNING! For safety reasons unscrew the feet (from screwed position) to the maximum extent of 5 mm(g.9....

[Page 34] Kenwood CK 700 A

34 MOVING THE COOKER WARNING: When raising cooker to upright position always ensure two people carry out this manoeuvre to prevent damage to the adjustable feet (g. 9.4). WARNING Be carefull: do not lift the cooker by the door handle when raisin...

[Page 35] Kenwood CK 700 A

35 PROVISION FOR VENTILATION • The appliance should be installed into a room or space with an air supply in accordan- ce with BS 5440-2: 2000. • For rooms with a volume of less than 5m 3 - permanent ventilation of 100 cm 2 free area will...

[Page 36] Kenwood CK 700 A

36 IMPORTANT NOTE This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation label attached on the appliance). • Appliances supplied for use on NATURAL GAS: they are adjusted for this gas only andcannotbeused�...

[Page 37] Kenwood CK 700 A

37 GAS CONNECTION The installation of the gas appliance to Natural Gas or LP Gas must be carried out by a suitablyqualiedandregisteredinstaller. Installers shall take due account of the provisions of the relevant British Standards Cod...

[Page 38] Kenwood CK 700 A

38 Fig. 10.2 gas pipe cooker rear protection Fig. 10.1 GAS CONNECTION GB Cat: II 2H3+ The gas supply must be connected to the gas inlet which is located at the rear of the ap- pliance(seegure10.1). If the connection pipe cross the cook...

[Page 39] Kenwood CK 700 A

39 REPLACEMENT OF THE INJECTORS OF THE COOKTOP BURNERS If the injectors are not supplied they can be obtained from the “Service Centre”. Select the injectors to be replaced accor- ding to the “Table for the choice of the in- jectors”. To re...

[Page 40] Kenwood CK 700 A

40 LUBRICATION OF THE GAS TAPS • Incaseofdifcultyinthegastapsoperation,callService. IMPORTANT All intervention regarding installation maintenance of the appliance must be fullled with original factory parts. ...

[Page 41] Kenwood CK 700 A

41 The appliance must be connected to the electrical network verifying above all that the voltagecorrespondstothevalueindicatedonthespecicationsplateandthatthecables section of the electrical plant can be...

[Page 42] Kenwood CK 700 A

42 FUSE DOUBLE POLE SWITCHED FUSED SPUR OUTLET Use a suitable FUSE in accordance with the appliance power rating ON CONNECTION TO FIXED WIRING A double pole switch must be provided no further than 2 metres from the appliance to the electrical suppl...

[Page 43] Kenwood CK 700 A

43 UK only If your appliance goes wrong within one year from the date you bought it, we will repair it (or replace it if necessary) free of charge provided: • you have not misused, neglected, or damaged it; • ithasnotbeenmodi�...

[Page 44] Kenwood CK 700 A

Code: 1103855 - ß2 ...